SLC Detailing: Porsche 911 Turbo S
Posted: Wed Jul 26, 2017 12:40 pm
Last week was the turn of this motoring Icon the Porsche 911 Turbo S! With 572HP it was my job to make it look as good as it goes!
The decision was made for a Gloss Detail on this stunning car. The process took in total 7 hours however working on such a car is never a chore! The treatment included the following
- Alloys cleaned using Dragons Breathe Fall put remover agitated where needed and thoroughly rinsed
- Vehicle about foamed with Bilt Hamber PH Neutral Snow Foam
- Washed using the two bucket method with grit guards and Autoglym Bodywork Conditioner
- Rinsed, dried and then full vehicle sparked with Dragons Breath to remove fall out. Thoroughly rinsed and dried again
- Bodywork sprayed with G Techniq Glue and Tar Remover. Thoroughly rinsed again. Stubborn areas sprayed again and rinsed
- Bodywork Clayed using Tac Systems Clay Cloth
- Bodywork cleansed using Zaino All In One Paint Cleanser
- Paintwork sealed using Angelwax Desirable Wax. First coat left for 2 hours before a second coat applied
- Door shuts cleaned using APC with soft bristle brush to assist. Once cleaned sealed with Fusso Sealent
- Glass Polished using Gtechniq G1 Smart Glass
- Exhaust Tips polished with Autosol
- Trim, engine bay plastics and Boot plastics dressed with Autoglym Vinyl and rubber care
- Alloys sealed using angelwax wheel sealent and tyres dresses using Tac systems
And now the results:
The decision was made for a Gloss Detail on this stunning car. The process took in total 7 hours however working on such a car is never a chore! The treatment included the following
- Alloys cleaned using Dragons Breathe Fall put remover agitated where needed and thoroughly rinsed
- Vehicle about foamed with Bilt Hamber PH Neutral Snow Foam
- Washed using the two bucket method with grit guards and Autoglym Bodywork Conditioner
- Rinsed, dried and then full vehicle sparked with Dragons Breath to remove fall out. Thoroughly rinsed and dried again
- Bodywork sprayed with G Techniq Glue and Tar Remover. Thoroughly rinsed again. Stubborn areas sprayed again and rinsed
- Bodywork Clayed using Tac Systems Clay Cloth
- Bodywork cleansed using Zaino All In One Paint Cleanser
- Paintwork sealed using Angelwax Desirable Wax. First coat left for 2 hours before a second coat applied
- Door shuts cleaned using APC with soft bristle brush to assist. Once cleaned sealed with Fusso Sealent
- Glass Polished using Gtechniq G1 Smart Glass
- Exhaust Tips polished with Autosol
- Trim, engine bay plastics and Boot plastics dressed with Autoglym Vinyl and rubber care
- Alloys sealed using angelwax wheel sealent and tyres dresses using Tac systems
And now the results: