RS6 not-starting
Posted: Sun Jun 02, 2019 7:38 pm
Hi all I'm new to the forum but have had my RS6 for almost 2.5 years. Car has been amazing so far with only small issues here and there until the other day.
I had fired the car up for the first time in a few days had no issues, drove and got gas, started fine again, then drove elsewhere shut it off for maybe 30 minutes, then it took a while to fire up, at this time there were no DTCs, so I let it sit a few and it fired up fine. Started driving and not even a mile down the road I lost engine power until it eventually cut out. I pulled over and checked for DTCs again. When the car died, the engine light was not flashing, no EPC light or battery light came on.
I unhooked the battery for 20 minutes and tried to start it again, and ever since then it has not started since. I've checked the fuel pump, fuel pump relay, which both seem to be OK, but I am getting codes now for all 8 cylinders "injector low circuits" as well as p0322 ignition "engine speed input circuit no signal"
I'm really lost on this and have not experienced this issue in the past. Maybe 2 months ago it did the not wanting to fire up thing one time, but since then up until now no other issues.
Any insight would be greatly appreciated, thank you.
I had fired the car up for the first time in a few days had no issues, drove and got gas, started fine again, then drove elsewhere shut it off for maybe 30 minutes, then it took a while to fire up, at this time there were no DTCs, so I let it sit a few and it fired up fine. Started driving and not even a mile down the road I lost engine power until it eventually cut out. I pulled over and checked for DTCs again. When the car died, the engine light was not flashing, no EPC light or battery light came on.
I unhooked the battery for 20 minutes and tried to start it again, and ever since then it has not started since. I've checked the fuel pump, fuel pump relay, which both seem to be OK, but I am getting codes now for all 8 cylinders "injector low circuits" as well as p0322 ignition "engine speed input circuit no signal"
I'm really lost on this and have not experienced this issue in the past. Maybe 2 months ago it did the not wanting to fire up thing one time, but since then up until now no other issues.
Any insight would be greatly appreciated, thank you.