Page 1 of 1
Smoke on low revs
Posted: Sun Jan 15, 2012 2:13 am
by mazsco@ntlworld.com
Hi there new to the forum and need some advice, currently on low revs and and motorway driving backing off the accelerator I get puffs of smoke from exhausts, blip the throttle again and it disappears, any advice or known issues?
Re: Smoke on low revs
Posted: Sun Jan 15, 2012 8:15 am
by chunky79
FON
Now the advice - don't use your phone while driving
Re: Smoke on low revs
Posted: Sun Jan 15, 2012 8:26 am
by chunky79
Was it black or white smoke?
Re: Smoke on low revs
Posted: Sun Jan 15, 2012 9:03 am
by bilko1
Welcome and
FON.
Black smoke = fuel
White smoke = water
Blue smoke = oil
Make a choice and let us know.
Re: Smoke on low revs
Posted: Sun Jan 15, 2012 9:31 am
by posterboyj
What colour is the smoke
Re: Smoke on low revs
Posted: Sun Jan 15, 2012 11:42 am
by chunky79
errrrr, what colour was the smoke??
Re: Smoke on low revs
Posted: Sun Jan 15, 2012 11:49 am
by mazsco@ntlworld.com
It's black smoke, could this be some seals that have gone?
Re: Smoke on low revs
Posted: Sun Jan 15, 2012 2:34 pm
by chunky79
is the car running ok apart from the smoke?
where in the world is thee??
Re: Smoke on low revs
Posted: Sun Jan 15, 2012 5:34 pm
by mazsco@ntlworld.com
Yes runs fine apart from this. I'm in the north east England area
Re: Smoke on low revs
Posted: Sun Jan 15, 2012 7:04 pm
by JCviggen
Best thing to start with is to check your codes with
VCDS or something. Sounds like a fueling issue, but there's a lot of sensors and other things that can cause that so to pin it down you'll have to check first if the ECU has fault codes stored in it.
Re: Smoke on low revs
Posted: Sun Jan 15, 2012 9:22 pm
by deanflyer
Im near Newcastle and have
VCDS if you need it.
Re: Smoke on low revs
Posted: Sun Jan 15, 2012 9:25 pm
by Shoppinit
^^What JC said. I'm betting on swiss cheese intercoolers or weak MAFs, or both.
Re: Smoke on low revs
Posted: Mon Jan 16, 2012 10:23 am
by mazsco@ntlworld.com
Pm set to deanflyer, wherebouts are u?
Re: Smoke on low revs
Posted: Mon Jan 16, 2012 10:50 am
by deanflyer
pm sent to you.