Page 1 of 3
Ride Height - How low to go ?
Posted: Sat Jun 21, 2008 1:57 pm
by WeaselRS6saloon
Hi,
I recently had KW's superbly fitted by Grizz at Unit 20 and I have been playing about with the ride height, but cant make my mind up where to set it at.
Just wondering what other people have their cars set at ?
KW Paperwork says between 340mm and 360mm from centre of hub to wheel arch.
I have the front set at 337mm (outside of what the paperwork says I know) and the back at 343mm (give a bit extra for the kids!).
Any ideas / opinions welcome....................
RE: Ride Height - How low to go ?
Posted: Sat Jun 21, 2008 10:39 pm
by Rupert
Can you post a pic? How does it look at 337?
RE: Ride Height - How low to go ?
Posted: Sat Jun 21, 2008 10:45 pm
by Golfather
Drop it like its hot
RE: Ride Height - How low to go ?
Posted: Sun Jun 22, 2008 12:38 am
by NumberoftheBeast
Fo shizzle ma nizzle.
Re: RE: Ride Height - How low to go ?
Posted: Wed Jun 25, 2008 3:58 pm
by WeaselRS6saloon
Rupert wrote:Can you post a pic? How does it look at 337?
Photos attached I hope !
RE: Re: RE: Ride Height - How low to go ?
Posted: Wed Jun 25, 2008 4:04 pm
by tombs
Ive never been a big fan of lowered cars...esp for such a big car it looks..well chaved. imo of course.
RE: Re: RE: Ride Height - How low to go ?
Posted: Wed Jun 25, 2008 4:46 pm
by Spacecowboy
Posted: Wed Jun 25, 2008 5:27 pm
by bigh
$hit, that is low!
Looks good as well
Posted: Wed Jun 25, 2008 5:55 pm
by philroach
dont you get any knocks on the bodywork , being that low ?? , and how bumpy is it !!!
phil
Posted: Wed Jun 25, 2008 6:36 pm
by grizz
Lower than mine .
Posted: Wed Jun 25, 2008 7:01 pm
by GardinerG
Grizz's as low as I would want it.
Posted: Wed Jun 25, 2008 10:24 pm
by Spacecowboy
philroach wrote:dont you get any knocks on the bodywork , being that low ?? , and how bumpy is it !!!
phil
only on the inside fander you must work a little bit !
it drives much softer as with the original drc...
Posted: Wed Jun 25, 2008 11:02 pm
by bigfra
Spacecowboy wrote:philroach wrote:dont you get any knocks on the bodywork , being that low ?? , and how bumpy is it !!!
phil
only on the inside fander you must work a little bit !
it drives much softer as with the original drc...
What suspension have you got and do you run it hard or soft.Mine is higher than yours and bounces/crashes about all over the place!!
Posted: Thu Jun 26, 2008 7:43 am
by Spacecowboy
first, that is not my car !
it is a suspension from h&r in a deep version...
Posted: Thu Jun 26, 2008 9:15 pm
by ElginEdition
I'm just wondering how low to go with the H+R's, when they get fitted
