I ve nearly completed the suspension and brake refurb on my RS6 Avant but struggling to find the last few parts which are.
Rear headlight level sensor
Front caliper pins and retaining plates
Rear anti roll bar bushes
Any links or help will be greatly appreciated.
Cheers
Help needed with parts
Re: Help needed with parts
Not sure about others but have seen the pins and retaining plates on Ebay from addiction motorsport for £50.
Re: Help needed with parts
https://www.ebay.co.uk/itm/226356161975
https://www.ebay.co.uk/itm/183380443395
https://www.ebay.co.uk/itm/316107039912
https://www.ebay.co.uk/itm/183380443395
https://www.ebay.co.uk/itm/316107039912
Daytona RS6 C5 Avant. Viper'd, Billies, Waggers, MTM box brain, C6 stoppers, xcarlink, R8 coolant cap (woohoo)
///M3 E46 | XC90 (V8, natch) | Passat GTE | RR Classic V8 flapper
"The major difference between a thing that might go wrong and a thing that cannot possibly go wrong is that when a thing that cannot possibly go wrong goes wrong it usually turns out to be impossible to get at and repair."
///M3 E46 | XC90 (V8, natch) | Passat GTE | RR Classic V8 flapper
"The major difference between a thing that might go wrong and a thing that cannot possibly go wrong is that when a thing that cannot possibly go wrong goes wrong it usually turns out to be impossible to get at and repair."
Re: Help needed with parts
Headlight level sensor - I "think" you can use this sensor and switch the mounting plate over:
https://www.autodoc.co.uk/ridex/16593115
That was certainly the case on the front one and I think I gave the rear a "looking at" at the time and confirmed the same applies.
The only thing I did change was the clip needed a little bit of packing under it to make sure it was snug onto the suspension arm and couldn't move.
https://www.autodoc.co.uk/ridex/16593115
That was certainly the case on the front one and I think I gave the rear a "looking at" at the time and confirmed the same applies.
The only thing I did change was the clip needed a little bit of packing under it to make sure it was snug onto the suspension arm and couldn't move.
"not a professional engineer, mechanic and mechanist"
Re: Help needed with parts
I brought the StrongFlex kit to bush my RS. Unfortunately I haven’t driven the car yet so can’t give any feedback other that they felt like a good quality product and all fitted perfectly.Frazz82 wrote: ↑Mon Jan 06, 2025 9:32 pmI ve nearly completed the suspension and brake refurb on my RS6 Avant but struggling to find the last few parts which are.
Rear headlight level sensor
Front caliper pins and retaining plates
Rear anti roll bar bushes
Any links or help will be greatly appreciated.
Cheers
https://strongflexuk.com/product/221445 ... -bar-bush/
Who is online
Users browsing this forum: No registered users and 71 guests