They have asked me to gauge numbers of how May would be roughly interested if any at all.
Price wise I don’t have a clue yet. This is solely just to see if they should try.
Aftermarket inlet manifold
-
Sxcarmyboi
- 2nd Gear
- Posts: 212
- Joined: Sun Jan 13, 2019 10:58 am
- Location: Maidstone
Aftermarket inlet manifold
I have been in contact with a couple of companies about making an aftermarket intake manifold for the RS6
They have asked me to gauge numbers of how May would be roughly interested if any at all.
Price wise I don’t have a clue yet. This is solely just to see if they should try.
Thos manifold was built for the 2.7 v6 engine. It’s also designed to run up-to 12 injectors depending on your build and requirements.
They have asked me to gauge numbers of how May would be roughly interested if any at all.
Price wise I don’t have a clue yet. This is solely just to see if they should try.
Thos manifold was built for the 2.7 v6 engine. It’s also designed to run up-to 12 injectors depending on your build and requirements.
C5 RS6 Avant
800+ BHP loading
1100+ ft lb loading
800+ BHP loading
1100+ ft lb loading
Re: Aftermarket inlet manifold
Have a look at the intake spacer rumler racing parts makes. It greatly increases the intake capacity. Rumler and KKS are running 1000hp+ builds with it. I'm guessing you may have already seen this though based on your incredible build!
Daily beater, Daytona Avant, MTM stage 1 & box map, wagners, bilsteins, hotchkis arb, milteks, Girodisc stoppers etc
Who is online
Users browsing this forum: Bing [Bot] and 27 guests