Front torque monut issiue

[smolam]

Hello everyone. I am happy owner of RS6 for a 2 years right now. Few month ago I’ve decide about making service of it. The torque converter was dying and because I needed to take the engine off, few other things have been done. Now I am about to finish but I have small issue. I needed to change front torque mount. I chose 034Motorsport product. After it is installed I noticed that there is a gap between mount and its holder (about 5 mm). When it is tighten, it is constantly stretched. All other mounts (engine and gearbox) are brand new OEM.

Should it be like that?

[AWT]

No,you need to put some washers to eliminate the gap

Sent from my MAR-LX1A using Tapatalk