Xenon Auto Leveling Warning Light.

[Knutts]

Since I have had my DRC replaced with PSS9's I keep getting the Xenon Auto Leveling light come on. The guys who did the work have been over it with a fine tooth comb and replaced the sensors etc but I am still having problems.

It ususally comes on after about 15 minutes of driving. Does anyone have any ideas?

[darrenswift]

Mine did that after fitting H&Rs.
Turned out the levelling bar by the N/S/R axle had snapped. Quick bit of Duct tape to secure it and all was well.
Hope you get it sorted soon

[Knutts]

I hope they would have noticed a snapped bar the amount of times it has been back. .

It's going back in next Wednesday. Hopefully they can fix it this time.

[el_ringo]

Mine is stuck on too, vag com wont rest it due to out of range but got an appointment with grizz in a few weeks so will have it looked at on the ramp.

[gorwanvfr]

Mine is stuck on too, vag com wont rest it due to out of range but got an appointment with grizz in a few weeks so will have it looked at on the ramp.

Had the same problem on mine. Don't laugh but had to lift the body of the car a couple of mm (Grabed the rear wheel arch and lifted it by hand)carried out the calibration using vagcom and it worked. Cleared the fault.

[el_ringo]

I was thinking about trying that!!

[gorwanvfr]

I was thinking about trying that!!

Have a look here at step 11 thats what helped me out
http://www.a4mods.com/index.php?page=we ... level.html

[el_ringo]

I managed to fix it using a jack. I set them a little high, jacked a tiny bit to get under 3.50v and set. When I dropped it down the few mm's it was the right level.

[GardinerG]

I had this problem at first too, car was raised a bit and then the Xenons were reset.

[Knutts]

Still early day but looks like it's been fixed.

Car has been raised slightly and the rear sensor adjusted so the bar is more horizontal.