Or maybe M4 but 8MM bolt (so it will sit in 6mm) far less than the big 10mm deep Lugs.. that need grinding off.Ashventini wrote: ↑Mon May 28, 2018 9:44 pmHi. I am leaning towards this way also.
Do you remember what size bolt you used.? I am looking at an M4 - 10mm length. So it will sit screwed in about 8mm as it sits on top of the plate. Obviously the smaller the screw size (M3, M4, M5, M6) means a smaller head sitting on the plate. Going to small I am thinking the thread may be too fine and strip.
My gut tells me to go with M4 thread (black gloss anodized so it wont be too noticeable on the black plate).
Thanks.
RS7 - Rear Calipers name plate Mod
-
- Neutral
- Posts: 10
- Joined: Fri May 25, 2018 10:06 pm
Re: RS7 - Rear Calipers name plate Mod
Who is online
Users browsing this forum: No registered users and 101 guests