Wiring schematic for RS6 (C5)??

[Daveperc]

Anyone got a wiring schematic I can download??

I have recently bought a switch to fit the third slot on the dash - normally it drives the electric rear blind, but I want to use it to switch on/off my additional parking aid . So I need to figure out where the various wires go to tap into them.

Also, anyone know if the plug that fits the switch is pre-wired into the loom, or do I need to get one of those too??

Which leads me onto the last question - how do you get the trim off to get to the back of the switch and the wiring!!

Any help (or better still a local enthusiast who fancies a morning helping!) welcomed

Thanks

Dave

[craigyb]

These switches are momentary, top outer are the lighting, lower outer are the push to make.

No pre wiring exists, so you would have to make your own. Get the lighting from the switch next door

[Daveperc]

Thanks Craigyb

Don't suppose you happen to know part numbers for matching socket (to fit the switch), and a suitable latching relay do you - and are there any spare relay slots anywhere. Ideally I want the unit on when ignition comes on, with option to turn it off by hitting the switch (and then back on again next time it's pressed).

I'll have to spend a few minutes with a pen and paper figuring this out I can see!

Dave