Alex's B7 RS4 Avant
Alex's B7 RS4 Avant
Figured I might start a build thread.
Picked my RS4 up a couple of weeks ago. 2007, Avus Silver Avant. Carbon trims, buckets, Bose stereo. Completely stock, and very clean, with 95,000km on the clock.
Drove it straight from Sydney to Adelaide (1400km) and it didn't miss a beat. Here's a couple sunrise shots from the drive:
Picked my RS4 up a couple of weeks ago. 2007, Avus Silver Avant. Carbon trims, buckets, Bose stereo. Completely stock, and very clean, with 95,000km on the clock.
Drove it straight from Sydney to Adelaide (1400km) and it didn't miss a beat. Here's a couple sunrise shots from the drive:
Re: Alex's B7 RS4 Avant
First mod starting today. Blackout the grille and badge. Pulled the front grille off following the excellent directions here:
http://www.audizine.com/forum/showthrea ... er-Removal
Bumper off:
Taped up and first coat of plasti-dip:
First time using this stuff but seems to be going on clean. Will update as we go along...
http://www.audizine.com/forum/showthrea ... er-Removal
Bumper off:
Taped up and first coat of plasti-dip:
First time using this stuff but seems to be going on clean. Will update as we go along...
Re: Alex's B7 RS4 Avant
6 coats on and looking good. A couple of minor mishaps in the paint but nothing that anyone will notice. Now to hope the possums don't walk all over it during the night as it dries...
Re: Alex's B7 RS4 Avant
Looking good Alex. You going to go for the rest of the black optic look too?
Just a question though; wouldn't it have been quicker and easier to unscrew the grille from the bumper than to cover the bumper up?
Just a question though; wouldn't it have been quicker and easier to unscrew the grille from the bumper than to cover the bumper up?
Re: Alex's B7 RS4 Avant
I looked at it but some of the clips are the one use type, and I'd heard a few people talk about breaking clips. Taping it up only took about 5min.
I'll switch the rear badge out for a black one I think, then see how I go for the window trim and roof rails. I'll probably leave the mirrors silver.
The only pause I have on the roof rails is because I'll use them relatively regularly to carry the mountain bike.
I'll switch the rear badge out for a black one I think, then see how I go for the window trim and roof rails. I'll probably leave the mirrors silver.
The only pause I have on the roof rails is because I'll use them relatively regularly to carry the mountain bike.
Alex's B7 RS4 Avant
Bar is back on. Managed to fix up the bumper gap somewhat as well. I had a really hard time loosening the lower headlight adjustment screw on the passenger side (LHS) so it's not as good as it could be, but far better.
Before:
After:
Before:
After:
Re: Alex's B7 RS4 Avant
MikeFish wrote:Looking good Alex. You going to go for the rest of the black optic look too?
Just a question though; wouldn't it have been quicker and easier to unscrew the grille from the bumper than to cover the bumper up?
This
Re: Alex's B7 RS4 Avant
Cat bypass and centre res delete happened today. Sounds much better! Still quiet enough with exhaust valves closed, but bordering on antisocial with the valves open under load at higher revs
Also, a package arrived today from the UK! (Thanks Mike)
Also, a package arrived today from the UK! (Thanks Mike)
Re: Alex's B7 RS4 Avant
Subtle change on the back as well. Plasti dipped the RS4 badge black, and removed the Audi badge. Just testing the look, if I like it, I'll order some proper black badges. The plasti dip looks ok from a distance but up close is obviously a fairly poor finish.
Re: Alex's B7 RS4 Avant
Thats a great headunit! I had one in my C5 RS6 and the amount of things you can change fiddle with is mind blowing but make sure you read the eleventy-billion page manual as pressing a single button can screw everything up (think it was to do with the radio).
***OLD*** Daytona C5 RS6 Avant - MRC'd - 500HP & 820NM (PistonHeads Link).
***NEW*** Daytona C6 RS6 Avant - MRC'd - 955HP & 1200NM (PistonHeads Link)
***NEW*** Daytona C6 RS6 Avant - MRC'd - 955HP & 1200NM (PistonHeads Link)
Re: Alex's B7 RS4 Avant
Looking good Alex!
Re: Alex's B7 RS4 Avant
Go for it
RS4 B7, Mugello Blue, K&W V3 & HR ARBs, set up by Centre Gravity, Milltek Valved Non Res & cat bypass pipes, BMC air filter, braided hoses, DOT 5.1, Terraclean, MRC Full Carbon Clean, MRC remap 448PS 477NM, 20" S7 alloys with 4mm spacers & Hawke spigots 66.6 > 57.1, AP Racing front discs. Sold Sept 2019. Now rocking an F80 M3
Alex's B7 RS4 Avant
Finally got this in... Mikes old Alpine deck (thanks Mike!).
Makes a huge difference to the interior, really modernises it, and the red theme matches the interior very well for a close to OEM look.
Makes a huge difference to the interior, really modernises it, and the red theme matches the interior very well for a close to OEM look.
Re: Alex's B7 RS4 Avant
Nice one Alex. Fits that space nicely with that surround doesn't it.
Re: Alex's B7 RS4 Avant
Liking this
Any more info please guys?
I wouldn't mind ditching the RNSE
What head unit is that? Facia plate?
Coding required?
Any more info please guys?
I wouldn't mind ditching the RNSE
What head unit is that? Facia plate?
Coding required?
Instagram : n_i_l_s
Who is online
Users browsing this forum: No registered users and 56 guests