Started with some machine polishing, used a DAS 6 with meguairs microfibre cut pad and microfibre compound.
Still quite and bit left to do and refine with a fine polish, but here are a few pics:
This was the car a few weeks after i got it:
And an interior pic:
Before polishing pics:
After pics:
And the rear lights:
Also fitted a set of OEM Audi carbon mirrors and wrapped the fuel flap gloss black.
Fitted a bigger intercooler, had to clean all the plastic parts behind the bumper while it was off lol
Before:
After:
Also removed the bar in the bumper:
And the new intercooler fitted:
Tried to wrap my splitter gloss black, epic fail, too big and awkward to wrap on my own and i made the mistake off taking all the backing off at one time, it was sticking to everything (kitchen table, fridge door)
I managed to do the small part in the middle of the splitter though:
Before:
After:
Gloss black centre caps and wheel nut covers fitted and plasti dip the rear badges.
Got to do the front badges now and also get some red vinyl to put back in the RS badge.
Had some bad scratches on my passenger headlight, so wet sanded them out as best i could and then polished.
Some of the scratches:
After wet sanding:
After a polish:
Also had a few deep scratches on the bonnet that weren't coming out by just polishing, forgot to take before pics.
After wet sanding with 2000 grit:
After 1st stage of polish:
Also fitted gloss black audi rings and plasti dipped the TTRS badge in black, not put the red back in yet as the red vinyl I order is not the right colour its a bit too pinky.
