Page 1 of 1
Anyone fitted RS4 throttle body to an S4 inlet manifold
Posted: Wed Mar 26, 2008 4:17 pm
by BRETTCOLLINS
Anyone fitted RS4 throttle body to an S4 inlet manifold?
RE: Anyone fitted RS4 throttle body to an S4 inlet manifold
Posted: Wed Mar 26, 2008 4:49 pm
by s4woody
your gonna need some sort of adaptor plate..IIRC the bolt holes dont line up unless the correct TB is used for the respective manifold...
Re: Anyone fitted RS4 throttle body to an S4 inlet manifold
Posted: Sun May 11, 2008 5:50 pm
by dazzer
BRETTCOLLINS wrote:Anyone fitted RS4 throttle body to an S4 inlet manifold?
Hi Brett,
Did you get any further looking into this?
Cheers
Daz
RE: Re: Anyone fitted RS4 throttle body to an S4 inlet manif
Posted: Mon May 12, 2008 8:42 am
by BRETTCOLLINS
For all the work needed, Didn't do it in the end. the throttle is only 4mm bigger. Anyway it is cheaper and better to go after market, but that is another story..