RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Jonny, Andy and anyone who has Milltek cat.

My mechanic is preparing to install the cat. but we found a problem. The OEMs have the sensors installed toward the front of the cat. However, the Millteks have slotted the hole towards the rear. Now, the sensor cable cannot reach the new location. Are we doing something wrong?? Do you have a picture of the Milltek installed?? I would be appreciated if you could post it here!!! Thanks in advance!!

Bem

You could always call Milltek direct! Tel: +44 115 944 0044 They are open now (9am in UK)

Nige.

I did, Phil reckons I could pull the sensor wire to reach the spot but I could, it is 12in out of reach!

Here's how to do it - clickety, click ! [img]images/graemlins/thumbs.gif[/img]