Fog light switch
Posted: Thu Dec 28, 2006 4:56 pm
Just replaced bulb that lights up symbol on fog light switch.
Wide Flat bladed screwdriver, with thin cloth over end to stop marking of plastic switch. Insert blade into top part of switch and gently pull towards you. It should move a couple of millies, I then tried doing the same at the bottom of the switch, but that just moved top part of switch back in again!!!
Back to top again, and just started pulling towards me again, but this time I continued pulling slowly but firmly.
Popped out rather sudden, but without any damage.
Top bulb lights up symbol when headlights are switched on, bottom bulb lights up when fog light switch is depressed.
Removal of bulb, use pointed ended plyers, and draw bulb out gently.
Hope this might help anybody who is about to tackle same job.
rs2315.
Wide Flat bladed screwdriver, with thin cloth over end to stop marking of plastic switch. Insert blade into top part of switch and gently pull towards you. It should move a couple of millies, I then tried doing the same at the bottom of the switch, but that just moved top part of switch back in again!!!
Back to top again, and just started pulling towards me again, but this time I continued pulling slowly but firmly.
Popped out rather sudden, but without any damage.
Top bulb lights up symbol when headlights are switched on, bottom bulb lights up when fog light switch is depressed.
Removal of bulb, use pointed ended plyers, and draw bulb out gently.
Hope this might help anybody who is about to tackle same job.
rs2315.