RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

MK Meet - Weds 1st Feb, 7:30pm at the Caldecotte Arms, Milton Keynes.

First MK Meet of 2012, any enthusiast welcome. Potential MK meet newbies please post below so we can look out and welcome you! Usual suspects please post your interest. Hosted by Tyresmoke, open to RS246 and Audi SRS. As mentioned previously, the food is very much part of this meet, and being less inclined to hang around in the car park in these darker colder winter months we'll no doubt eat slightly earlier.

For any newcomers (or forgetful old timers) the Caldecotte Arms pub is by the junction of the A5 and the A4146 right next to the oddly shaped - and now smoothly resurfaced - roundabout under the A5 (great for testing your Milltek). Look for the Windmill! Coming off the dual carriageway, drive down as far as the pub and then turn left towards the outside 'arc' of the car park - the top tier so to speak. New map attached following prompt from DK!

The Caldecotte Arms
Bletcham Way
Caldecotte
Milton Keynes
Buckinghamshire
MK7 8HP
01908 366188

This coming Weds chaps.

Happen to have that day off work in lieu of weekend, S4 overdue a clean, hasn't been washed since Decembers back-to-back Ace Cafe and MK meet. Went Xscape and Theatre District last night, rain on roof had frozen when I got back to the car, you gotta love quattro when its hovering around zero

Depending if I finish work in time and my Milltek has been fitted I'll be there.

Nice one, dropped you a pm with my contact number in case its chilly / raining and we duck inside early before you arrive - its a big pub, we sit upstairs once in a blue moon too. That offer goes for anyone else too - just pop your name in this thread.

Did you decide to go valved in the end?!

Ian_C wrote:
Did you decide to go valved in the end?!

No thought what the hell and went non res non valved

Quality - debating whether to try a set of straight non-res' pipes in my [current] resonated system - no valves on the S4 Milly of course

Ian_C wrote:Quality - debating whether to try a set of straight non-res' pipes in my [current] resonated system - no valves on the S4 Milly of course

I soo hope the exhaust arrives by the 1st will give me chance to try it out

Am not too far away so may pop along, I'm a noobie and won't know anyone so be kind

This pic gives a good idea where to park up, the top tier / outside arc of the car park. David, good to chat to you via pm, you've got my number. I'll be there for 7:30pm and will leave my sidelights on if I'm first to arrive

Ian_C wrote:This pic gives a good idea where to park up, the top tier / outside arc of the car park. David, good to chat to you via pm, you've got my number. I'll be there for 7:30pm and will leave my sidelights on if I'm first to arrive

Ooh... do you leave your courtesy light on too and wave a little hanky ... if you're "up for it" ?

Nah, double flash of the headlights for that Tim.........

Fingers crossed I'll be there.

The only downside My Milltek won't be fitted

The guy who was fitting it tomorrow can't do it now until nxt week

rs4blacked wrote:Fingers crossed I'll be there.

The only downside My Milltek won't be fitted

The guy who was fitting it tomorrow can't do it now until nxt week

Did you get my message?

Nevermind! Tim, you going to join us, going to be a nice line of V8 Avants: if not, see you Ace Cafe Sunday yeah?!

DavidRS4 wrote:

rs4blacked wrote:Fingers crossed I'll be there.

The only downside My Milltek won't be fitted

The guy who was fitting it tomorrow can't do it now until nxt week

Did you get my message?

did you message in pm if so no i didn't