RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Hi

I have searched around on the forum but cant seem to find an old post that mentioned this...I am sure it must have been discussed before... I have the B7 disks and callipers and am looking at putting the B7 alloys on (9x19 with 255/30/19). Would this work on a B5 with standard suspension? I have spacers on my OEM 18s (I think 15 at back and 10 at front).

Would this work with or without spacers without any rubbing or is there a problem with this setup? sorry not very clued up on this type of thing.

Many thanks

Ive seen a pic on here of someone whos done it,it looked well i dont recall any mention of having to mod to do it

B7 alloys are ET29 IIRC, and B5's ET20

It might just clear without, but would give much much better clearance and also look better if you keep the spacers.

shouldnt be problem i am sure i have seen a couple of cars with the same modification will have a look further and report back.

I run 15mm spacers with this set up no issues, could even run with just a 10mm spacer on front.

ah cool thank you very much for the feedback, I will post some pics if the seller comes back to me on the B7 alloys.