RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

I am getting an RS4 suspension installed on my S4 and I wanna do a 4-wheel alignment, but they don't have the right alignment numbers for RS4 to do it properly, all they have is the S4 numbers.

Anyone's got those numbers to share please?

Thanks!

anyone with access to dealer DB or maintenance manual for RS4 would know this... I am in Canada so we don't have RS4 and therefore no access to that info.

Hi there just had my RS4 alligned and these are the spec's.also try (B6/B7) avant sport suspension A4/S4/RS4 quattro:2001-

Front
left specified range right specified range

Camber -1deg35' -0deg22' -1deg35' -0deg22'

toe 0deg05' 0deg15' 0deg05' 0deg15'

turning angle diff -1deg36' -0deg36' -1deg36' -0deg36'

toe raised 0deg07' 0deg21' 0deg07' 0deg21'

cross camber -0deg30' 0deg30'
total toe 0deg10' 0deg30'
cross toe raised -0deg10' 0deg10'


Rear left spec range right spec range

camber -1deg50' -0deg50' -1deg50' -0deg50'

toe 0deg08' 0deg15' 0deg08' 0deg15'

total toe 0deg15' 0deg30'
thrust angle -0deg10' 0deg10'

hope this helps, deg= degree's '=minutes

THANKS A LOT MATE!!!

That's exactly what I was looking for... cheers!

No problem happy to help.

p.binks wrote:Hi there just had my RS4 alligned and these are the spec's.also try (B6/B7) avant sport suspension A4/S4/RS4 quattro:2001-

Front
left specified range right specified range

Camber -1deg35' -0deg22' -1deg35' -0deg22'

toe 0deg05' 0deg15' 0deg05' 0deg15'

turning angle diff -1deg36' -0deg36' -1deg36' -0deg36'

toe raised 0deg07' 0deg21' 0deg07' 0deg21'

cross camber -0deg30' 0deg30'
total toe 0deg10' 0deg30'
cross toe raised -0deg10' 0deg10'


Rear left spec range right spec range

camber -1deg50' -0deg50' -1deg50' -0deg50'

toe 0deg08' 0deg15' 0deg08' 0deg15'

total toe 0deg15' 0deg30'
thrust angle -0deg10' 0deg10'

hope this helps, deg= degree's '=minutes

Are you sure these numbers are correct? If so, the car has to be setup with positive Toe (toe out)...

I aligned my S4 with RS4 suspension and they set the toes at 0.0 and it doesn't handle well... but still not sure if it makes sense to toe out the car....

Anyone has any ideas regarding this?

Thnx

Any help out there?

When you say fitted RS4 suspension - do you mean just the dampers and springs? If so, surely the S4 geometry settings are still what you need?

The toe is definitely negative.
Never positive.
G