RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

I was surprised by the feeling of a lack of pressure on my new RS4, so i took the pressure with a gauge.

Has somebody already been confronted to this kind of problem on S4 or RS4 biturbo?

No doubt 3 issues :
- CHECK ENGINE that put the system in safety control and reduce to 0.5bars (7.25psi)
- Leak in the pressure system
- one turbo out


Thanks to help

Fred

Bloody Hell! This is bizarre! The last time I was on I mentioned about this that some of you guys might have boost leaks and not know (this happened to me) I was reading 0.5 constant and didn't think anything of it until I had a re-map and it was still at 0.5. If it's lack of boost the first thing you should check is that all hoses are connected (also at DV's) as a hose could be leaking or even slipped off, it's as simple as that!

Has your car gone into Limp mode?

If it has, I would doubt it was a leak!!!

911TT_STEVO wrote:Bloody Hell! This is bizarre! The last time I was on I mentioned about this that some of you guys might have boost leaks and not know (this happened to me) I was reading 0.5 constant and didn't think anything of it until I had a re-map and it was still at 0.5. If it's lack of boost the first thing you should check is that all hoses are connected (also at DV's) as a hose could be leaking or even slipped off, it's as simple as that!

Has your car gone into Limp mode?

If it has, I would doubt it was a leak!!!

Thanks, but no limp mode

have u had the codes checked with VAG-COM..that will give u the sort of info u mite need..could be a MAF sensor or EGT sensor,s or like u say a poss boost leak..where about are u and look in the VAG/DTC section in the sticky and see if a member is close so u can meet and get it checked out..then your,ll no what way to turn..

after checking, it was coming from one of the two dumpvalves. So i ordered 2 forge motosport ones today !

I did change the dump valves and did erase faults, i had 14psi instead of 20 psi (as it has been remapped) and the system came into fault .

I 've got 0.5bas back

what are the fault codes..and have u had the basic settings done or had the throttle position reset..

s4woody wrote:what are the fault codes..and have u had the basic settings done or had the throttle position reset..

The error fault is :

"mélange (air/petrol admixture) too poor"

I did order a MAF sensor BOSH to AUDI.
I hope this is coming from it.

fred