Page 1 of 1
New turbo kit GT25r>> 630 WHP and 700++ HTQ
Posted: Tue Jan 17, 2006 11:04 pm
by AFAP18
Well
It looks like our beloved motor has a new upgrade which consists basically on the adaptation of the garrett turbos with bigger injectors.
No need to open the engine.
Have a look here:
http://www.autospeedperformance.com/
Regards
WOt
RE: New turbo kit GT25r>> 630 WHP and 700++ HTQ
Posted: Wed Jan 18, 2006 12:22 am
by Mik
Dude..... where have you been?
Mik
Posted: Wed Jan 18, 2006 2:20 am
by 911TT_STEVO
Bollocks!!!
No Upgraded Piston / Rods / Cams / Head work etc, put this in your car and 1 month later BANG!
Huge Turbo Boost and a ECU Program doesn't cut it for me!
And if thats the Dyno Graph, a few mini spikes in there compaired to the smooth stock graph.
Main concern would be the engine holding up to the extra boost!
Posted: Wed Jan 18, 2006 11:26 am
by Mik
Think the setup is very cool. But I agree boost seems high on stock compression ratio even with the stronger head bolts. Think I would use the kit on an RS4 engine or lower the compression to be safe. I wonder who did the mapping....
Mik
Posted: Wed Jan 18, 2006 10:51 pm
by AFAP18
Mik
What do you mean? been where?
I guess stevo is underestimating the pottencial of our cars. Let 's see what happens.
It was as partnership with APR.
Regards
WOT FREAK
Posted: Wed Jan 18, 2006 11:29 pm
by Mik
Just kidding mate....several posts elsewhere in the forum on the subject already
Mik
Posted: Thu Jan 19, 2006 9:46 pm
by AFAP18
Sorry, did not realise that. I guess just swapping the turbos would make a dif. since you will put more boost inside. I say that because the ECUs are not the same spec we have in Europe (Brasil).
Posted: Fri Jan 20, 2006 8:34 am
by smurfbus
Stevo: I dont know what you mean by stock graph but the one I've seen was another kit against GT25 kit. the other line was smoothed as they usually are. the gt25 graph was as dynoed w/o smoothing.
I dont think APR has anything to do with that code. It was done in NJ locally by European Performance Labs (EPL) and Mark.
Posted: Sun Feb 19, 2006 8:23 pm
by s4orce
smurfbus wrote:Stevo: I dont know what you mean by stock graph but the one I've seen was another kit against GT25 kit. the other line was smoothed as they usually are. the gt25 graph was as dynoed w/o smoothing.
I dont think APR has anything to do with that code. It was done in NJ locally by European Performance Labs (EPL) and Mark.
No, it was done by Mark@ASP in New Jersey. I agree though. 26-28 Psi on a stock motor wouldn't be terribly long for this world would it? without upgraded rods/pistons and a little compression lowering aren't you asking for trouble?