My idle got a bit rough and shaky, constantly changing between 740-800 rpm or 760-800 rpm I don't remember if it was 740 or 760.
Anyone experienced this?
Wonder what can be done and what causes this...
Thanks in advance.
Jumpy idle
RE: Jumpy idle
They idle like a pig anyway.....
2001 Avus Silver RS4 B5 60k on clock, MRC Custom Remap, Sunroof, Bluetooth prep
2006 Daytona Grey RS4 B7, RNS-E - SOLD
2006 BMW M6 - GONE
2006 Daytona Grey RS4 B7, RNS-E - SOLD
2006 BMW M6 - GONE
RE: Jumpy idle
2001 Avus Silver RS4 B5 60k on clock, MRC Custom Remap, Sunroof, Bluetooth prep
2006 Daytona Grey RS4 B7, RNS-E - SOLD
2006 BMW M6 - GONE
2006 Daytona Grey RS4 B7, RNS-E - SOLD
2006 BMW M6 - GONE
RE: Jumpy idle
Just put a rather low quality video of my idle, please see the shaky hand:
http://www.youtube.com/watch?v=SzKyOEDGm14
http://www.youtube.com/watch?v=SzKyOEDGm14
- Virdee Autos
- Trader (Expired)
- Posts: 2546
- Joined: Sun Jun 05, 2005 6:27 pm
RE: Jumpy idle
You could try to clean the throttle body, and then adapt with VCDS
OR maybe a air leak. Again go via measured block values on VCDS to check.
OR maybe a air leak. Again go via measured block values on VCDS to check.
Virdee Autos ~ 07950-526592
Noggy Blue RS4 - 710N's | Supersprint Exhaust | RS6 Calipers/RS4 Discs | Aero Wipers | B7 rear wiper | Pioneer AVIC-F10BT | Alcantara dash | Alcantara headlining | 15mm spacers | Pentagon Tints/Supaglass | After-run mod | Carbon steering wheel | R8 engine bay caps | Brushed Alu plate plinth |
Noggy Blue RS4 - 710N's | Supersprint Exhaust | RS6 Calipers/RS4 Discs | Aero Wipers | B7 rear wiper | Pioneer AVIC-F10BT | Alcantara dash | Alcantara headlining | 15mm spacers | Pentagon Tints/Supaglass | After-run mod | Carbon steering wheel | R8 engine bay caps | Brushed Alu plate plinth |
RE: Jumpy idle
Right after my n249 delete (straight line to dv's), my jumpy idle was gone.
2001 Avus Silver RS4 with 60k miles
100 cpsi full Milltek
710N DV
Awe Tuning Center Vent Boost Gauge
N249 delete
100 cpsi full Milltek
710N DV
Awe Tuning Center Vent Boost Gauge
N249 delete
Who is online
Users browsing this forum: No registered users and 106 guests