RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Hi

Please remove the paint.



Tom

Hi

The rear part will be, R8 GT



Tom

Hi

+10,2% / +9,0%




Tom

Hi

Original Audi R8 facelift rear diffuser carbon in new condition without damage.

Price 1800 GPB plus shipping

Tom

Hi

Exhaust manifold set R8 V10 Gen1 right and left with 50,000 KM mileage.
Fixed price 1000 GBP plus shipping with DHL.

Tom

Hi

Full carbon fiber at 2.1Kg.
A reduction in weight to the series of 5Kg.



Tom

Hi The V8 is a bit critical in the engine's heat balance and there are two thermostats 87 ° -104 ° and from 2010 85 ° -95 ° degrees. As a Heissland version, there is an additional water pump that is only coupled with the fans when the air conditioning is switched on, so not perfect on the Audi side....

Hi

Current value + 7.9% and + 7.0% the highest value ever achieved.
More fuel means more torque and power.




Tom

Hi The test with the foam filters is over, they are worse than the K&N. Image 1 shows the measured value block 032 at the time of September 2020 and there is a small amount of carbon deposited on the inlet valves. image 2 shows the lambda learning value at which the foam filter 1100 KM were operated...

Hi

Let's see if this carbon / aluminum anti roll bar can be installed.
3.17 kg is its weight for the front axle.



Tom

Hi Shortly before the start of the season there is a new diffuser. The old diffuser from 2013 was too aggressive for me and the current one is optically very close to the GT diffuser. New https://www.imgbox.de/users/speedrs4/IMAG6286.jpg old https://www.imgbox.de/users/speedrs4/DerArsch.jpg Tom

Hi New year and let's go, further modify. I've heard that filters with a foam cover should be better than series and I'm interested in whether they're better than my big K&N. The test with a vacuum cleaner was 1 to 1, both of which had a pressure of 0.01 bar generated. https://www.imgbox.de/users/sp...

Hi Removing the air conditioning compressor is too much work. Remains where he is. The V8 has parts that can be replaced by lightweight V10 parts. There are the hoses on the cooling water box, inlet and outlet made of aluminum from the V10. V10 https://www.imgbox.de/users/speedrs4/Nachlaufrohr.jpg V...

Hi I made the decision to dispose of the air conditioning this winter. I haven't used the air conditioning for years and thus the weight of the R8 is reduced by 10-12 kg and the loss of power due to the air conditioning compressor, which is always idling, is eliminated. https://www.imgbox.de/users/s...

Hi

It is quite a sensation that this motor has over 600 NM torque, 679NM to be precise.

The torque barrier was found and eliminated.



Tom