RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Looking for a front exhaust pipe (upline from the two cats).

Does anyone happen to know:

1. CO2 rating for RS2 with OEM exhaust system
2. CO2 rating for RS2 with full Milltek exhaust system

Everywhere I look just says 'n/a'!?
Thanks,
Tony

AlWyn, thanks for suggestions. Am rather embarrassed ... turns out it was immobiliser-related. Following an S2 Forum comment re security I tried locking car with remote and then unlocking ... car then started immediately. I had recharged the flat battery following return from overseas and had probab...

Vehicle has been unused for a couple of months while I was overseas. Upon return I am finding that vehicle won't start straightaway and oil pressure warning light comes on a few seconds after I stop trying to start it. Any ideas where I should be looking? Prior to today's attempt it did start after ...

'..Ive got the same in the back of mine Tony...only 2 more and we could make a set ..'

No need ... that one is sitting on top of its three identical siblings!

DickyC wrote: Well done for keeping the SP8000s going so long. Yours are probably the last ones!

My drivers seat back adjustment control is not working, although the other control (that angles the whole seat) is. Had a poke around under the seat for any loose connections but could not find any. Has anyone had this problem? I imagine the same fuse is used for both controls so imagine that is not...

Pause1,
You will probably have seen the Blue RS2 is back on TradeMe ... with a Buy Now. Go for it!

You might be in luck! ... blue as well!

http://www.trademe.co.nz/Trade-Me-Motor ... 600042.htm

I would like to replace amber with clear....could someone suggest where I could obtain a set? Apparently they are not available from Audi ...or Porsche .... used in 993 I am told.

Would STRONGLY recommend that you get this sorted properly (new windscreen or seal if necessary). I have some horror pics taken from behind the dash cowl of a CQ that had a similar leak .... it may also get into the door hinge mounts etc! Don't do the sealant as you will not ncessarily know when tha...

I have just had a complete Milltek system (incl. downpipe and cat) installed by one of the local Audi agencies, replacing what was probably the ex-factory system (car has done 82000km). Initial impression is that it has lost power, noticeably the turbo kick at 3000rpm. Any ideas where should I start...

I have just received a system for an RS2, in two packages. packing slip for the package containing the downpipe and cat assembly says ' Audi S2'. could someone confirm that these parts are the same for the S2 and RS2? (Milltek part nos. MSUR15 and MSUR16). I imagine this is the case but just want to...

I concur with the previous comments re a/c, having just had a repair job...NZ$ equivalent of UKP 800, fortunately covered by insurance. Labour was 15.65 hours...apparently the whole dash assembly has to be dismantled to get at the a/c components. This was after an initial test/repair for lack of pre...

You're right...but I have a 'spray' of stone chips on the sill behind each front wheel....I don't know how they got there!....so thought that a small possibly curved flap would divert some of the road debris away from the paintwork. There are a couple of screws at the inner front of the sill that co...