RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

ignition module on the top of the airbox?

new it wouldn't take you long Grizzly )

just don't want to hack up a brand new mani but I will should there be no used one available... thanks

I thought it would rot the petrol hoses, or something??? good theory , the second paragraph is interesting copied and pasted - ***One is the elimination of bare magnesium, aluminum, and rubber parts in the fuel system. Another is that fuel pumps must be capable of operating with electrically conduc...

I hope someone gets some use out of this post

for information if youwant a bosch motorsport one it is 806euro's, i'm not

on the bosch motorsport site there is a 4 bar MAP, iirc Dodgydave is using a 5 bar MAP sensor? either of these would be fine, the bosch motorsport one is pricey is there an alternative aftermarket one? TIA

a6's don't have one and are ok, safe bet is trig's pipe solution

looks more like absolute on that test with the dyno chart

it says below 28psi spike to 23.4 at red, 22psi requested?

spen its more that it is physically impossible to flow beyond a certain point, at that point there is a cut off , the compressor will not be driven to flow more once this point has been reached, back pressure is relatively small at these speeds and not the issue. exhaust gas is actually quite resist...

they were rs4 k04's, physically impossible for the to deliver more

no problems they've always been very helpful

he did a motor swap to a v8, he's using his flywheel as an example of the work...

1st & 2nd syncro carbon coated + hub no gears included or needed

Jim the repair kit is only 180 from vagparts