RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Hi Mark - just edited my post as my garage entrance is 210cm wide (once inside I have 50cm width either side of the 210cm for doors to be opened) - so if I get the reversing spot on I have about 2cm either side and I can reverse in without retracting the wing mirrors, if I line the car up precisely...

Remember it's the width of the garage door that is the most important element, not the internal width of the garage (if the door is not as wide as the internal width)! I garage mine in my single garage - but I put an old Ikea 6ft long mirror up (sideways on - and at headlight / lower front windscre...

My garage is 5m square (external). I had to knock a hole through to get sufficient length. I park the Beast and a Focus ST in there and it's very tight - both cars need to be tight against their respective walls. It leaves me about 60-70cm to get the door open and that's quite tight for someone my ...

Mcw543 wrote: ↑

Wed Aug 16, 2023 5:00 pm

Whereabouts are you ? I'm sure someone local will pop round and try it....

That would be awesome if anyone is local - I'm in Folkestone, Kent.

feeltheburn wrote: ↑

Sun Aug 13, 2023 8:15 pm

IMG_1317.png

From 2014 sales brochure

Thanks so much, that's really helpful, and a lot clearer than most of the other information out there...

Would still be good to hear from anyone who does garage theirs, just to see how feasible it will be given the dimensions of my garage.

Hello everyone, I'm hoping to buy a C7.5 RS6 in the next couple of months, but am concerned it might not fit in my garage. I currently have an R231 SL63 AMG, which gets through the garage entrance fine, but is tight inside in terms of opening the door and getting in and out. Anything more than a cou...