RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

feeltheburn wrote: ↑

Sun Mar 12, 2023 6:01 pm

[picture on ELSA shows saloon but gives the idea - it is well worth getting ELSA for yourself if you plan any DIY repairs]

Hi....How do i / what is the best way to get ELSA?

Thanks in advance!

Same issue withe mine. Water dripping from bonnet release handle area....
Anyone got any updates on resolution?

I've recently had the second set of oem disks and pads all around. I still have a few issues with brake judder.

I'm thinking about new pads (non oem)...but no idea where to go....any advice very welcome

I have exactly the same issue.
Your photo shows water running from the bonnet release handle. Mine in exactly the same.

Sounds like @jim hasletime is correct. Just need to work out where needs a good blow out with an airline...

Listening to the video, it is the engine that doesn't sound right. How does the car drive and how does it sound under load? It drives and sounds like it should in general, just have to ignore the stupid chirping. This started when I had the centre section replaced under warranty (bracket sheared of...

Guys, this is my RS6 with a Milltek non-res cat back systems installed, it sounds terrible, that high pitched chirping you can hear in the video is audible 80% of the time, and the overriding sound from the car in town and even on the motorway. The fitting garage contacted Milltek with a video to ha...

Bumping back to top of the forum....
I still have a chirping Milltek - sounds bloody awful...
Does anyone have any experience? Is it a Milltek issue? Or Milltek on RS6 C7 issue?

Any information would be really useful please?

Thanks!

I didn't know there was a change wheel mode....how do you find that? Mines a pre face-lift 2013.

I disconnected the battery for 20 mins today, but no change.

What kit should I buy to read and reset faults?

Hi Guys I had the car detailed last week, looks awesome....but... Since then I cannot turn the traction control off! According to the detailer, a fault came on the dash when he switched the car on, on one occasion....it was a picture of a dampener and he thought is said something about suspension. W...

@Ashventini

Did you ever find the source of the noise? I have the same.

Hi Guys This one is driving me mad. Its getting cold out...and windows will steam up! Aircon ON = Freezing cold air regardless of heat setting, even when engine hot = its colder inside the car than outside! Aircon OFF = Windscreen steams up Windscreen demist button = Freezing cold air for ever Recir...

@r33

Can you give me an idea of install please?

Where did you pick up power for the AMP?
Did you have to route speaker wires from head unit to AMP? - is this easy? How did you do it?

Thank you

Hi Guys I had a new Milltek non-res cat-back fitted yesterday. It sounds awesome in general, exactly what I wanted. But I have the chirpy sounds on overrun too. Noticed this morning while driving in built up area. The sound seems to last (duration) the same amount of time in all situations. Road or ...

Morning! Only last week when walking up to the back of the car I noticed it was 'leaning' a little. Turns out one side sits about 10mm lower than the other. I have DRC. Would i be correct in assuming it can't be anything to do with the hydraulics - assuming that when sitting stationary, parked witho...

I believe so buddy, just check your wheel hub details: 112 x 5, 66.5mm centre is the spec of my wheel hub. This means their are 5 threaded holes equally spaced on an imaginary 112mm circle (thats the 112 x 5 part), then there's the 66.5mm centre bore. Yours is the same as mine according to https://w...