RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Covkiller wrote: ↑

Fri Apr 27, 2018 2:32 pm

That's Met Office code for pissing it down and blowing a gale force 9

Mark, what time will you be leaving Lymington ?
I’ll be coming from Milford on Sea, about 10mins away from Lymington.

Hi, can anyone help with the following dilemma?? I have had a drivers side drive shaft replaced, the old drive shaft was not sitting correctly in the CV Joint, it was sitting at the edge of the hub causing the outside edge to wear excessively thus causing a failure. The shaft also showed signs that ...

Shockerboy wrote: ↑

Tue Nov 07, 2017 8:19 am

I know the suspension on these cars run a high motion ratio but does anyone know what the standard spring rates are ?? The spring rates mentioned are hi is this car a track day car or daily ??

It’s a daily.

ixi_ixi wrote: ↑

Sun Nov 05, 2017 6:34 am

Here you go mate:

https://www.demon-tweeks.co.uk/motorspo ... on-springs

Front: 2.5" ID x 10" long 750lbs
Rear: 2.25" ID x 6" long 1200lbs

Thanks Simon

Could anyone point me in the right direction please, I’m looking for a decent set of new springs to fit on my newly acquired Stasis suspension. I’m told I need 10” front and 6” rear with a 2.5” id They also need to be rated at approx 750lbs for the front and 1200lbs for the rears. Does anyone have a...

^^^^^^ This, I have the same and is a vast improvement over standard in my opinion.

Hi Mike, in a word yes.....
I like the diamond cut face at the moment, I need to have the passenger from re done as it got attacked by a motorcyclist's foot peg
I was going to have them done for aitp but I'm away on holiday then. I'll post a couple of pics when there done.

marc1 wrote: ↑

Wed Jun 28, 2017 12:32 am

^ more pics of the whole car please.

As requested

are you local to b'north?? I recognise the wheel caliper combo! Yes :bigwave: I thought so. Your car is gorgeous mate, and sound epic. I have a daytona grey avant also. i'll give u wave if i see you about. :bigwave: Thank you, I have seen you around town a couple of times but I've generally been in...

I might come and meet you all on the 9th, as I'm only 1.5hrs away. Do you have any routes planned yet ? Sunday is mainly around the beacons area/south wales. We'll be doing mid/north wales on the saturday. Ok no problem, if you can let me know the start location and time for the Sunday I'll meet yo...

TommyC wrote: ↑

Tue Jun 27, 2017 5:24 pm

NJMAudiRS4 wrote: ↑

Tue Jun 27, 2017 10:29 am

RS6 peelers and C7 RS6 twin spokes sitting on standard DRC with h&r lowering springs.

are you local to b'north?? I recognise the wheel caliper combo!

Yes

I might come and meet you all on the 9th, as I'm only 1.5hrs away. Do you have any routes planned yet ?

No not me

I was down that way the week after though.

RS6 peelers and C7 RS6 twin spokes sitting on standard DRC with h&r lowering springs.

It looks as though the cats have been removed and also you have centre resonated boxes on your exhaust system. Regarding smoking/ burning issues, what fuel have you put in, I wouldn't put anything less than Shell V-power in. My old exhaust system was quite similar pushing out black smoke like a dies...