First Mod - Black rings go on front

[steve_70]

The front was the first to get the treatment, rears coming up next

Some befores and afters from different angles

[MikeFish]

Much better!!

[steve_70]

Much better!!

'Miles Better' even

Rears being done tomorrow if rain stays away

[Noyjatat]

No thanks

[johnnydog]

Each to their own of course, but black rings aren't for me (on an RS4, that is... and any others come to think of it....)

[HYFR]

Staff car!

[MikeFish]

Much better!!

'Miles Better' even

Rears being done tomorrow if rain stays away

I only got the reference after clicking the photo which took me to your bucket!!

[steve_70]

Much better!!

'Miles Better' even

Rears being done tomorrow if rain stays away

I only got the reference after clicking the photo which took me to your bucket!!

[ARSEY4]

Mmmmm im not sure, could you just post a photo from another angle?

[RossDagley]

Pop in/out with no drama? B7 was a bumper off job iirc (well, the grill was for sure)

[steve_70]

Pop in/out with no drama? B7 was a bumper off job iirc (well, the grill was for sure)

Came off no drama,no removal required with my method; I used a thin plastic trim remover tool to get under badge and a very thin blade screwdriver with some tape over the end to protect to lever on the clips.... be very careful not to lever on the outer black bezel or slip and scratch; so below is an alternative but will result in vandalism to snap lugs off to remove; depends if you want to have to go and buy a new badge if you need to go back to silver them at any point.

There was thread I saw somewhere where the clips had been accessed fron the rear and pressed down with screwdriver, I think he said it was fiddly and in the end he just snapped the lugs off from the back and lifted it off;

[kmpowell]

Looks like they're good quality, how much, and where from?

[steve_70]

Looks like they're good quality, how much, and where from?

Here we go (RS4 badges on page 1).....http://www.raywelldesign.com/product-ca ... ges/page/2

I fancy a set of their whels also
http://www.raywelldesign.com

[milesg]

Very nice sir!

Welcome to the black rings club....

[RossDagley]

Pop in/out with no drama? B7 was a bumper off job iirc (well, the grill was for sure)

Came off no drama,no removal required with my method; I used a thin plastic trim remover tool to get under badge and a very thin blade screwdriver with some tape over the end to protect to lever on the clips.... be very careful not to lever on the outer black bezel or slip and scratch; so below is an alternative but will result in vandalism to snap lugs off to remove; depends if you want to have to go and buy a new badge if you need to go back to silver them at any point.

There was thread I saw somewhere where the clips had been accessed fron the rear and pressed down with screwdriver, I think he said it was fiddly and in the end he just snapped the lugs off from the back and lifted it off;

Excellent thanks!