RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

I've just done a deal on a pre facelift panther black RS6 and this forum has been really useful in helping answer questions I had.

Just a couple of questions I'm after some help with. I'm looking to buy the front & rear black gloss rings but can't find the exact sizes for the RS6 listed anywhere? Can anyone help? I'm going to get them off eBay I think as from what I've read the Raywell rear one is slightly smaller.

Also, has anyone sourced a front RS6 badge in black?

Thanks in advance.

There you go mate

http://www.raywelldesign.com/

I'll dig out the info on my ones

Who will notice the size difference in the rears? You'd have to be holding them side by side to tell the difference. I didn't measure the rears as I had no intention of fitting the rear rings, but when I checked the raywell rear ones for my wife's car the difference was only noticeable when holding one against the other.
And the front raywell ones fit.

Not found a black badge for the front yet but haven't really looked.

MikeFish wrote:Not found a black badge for the front yet but haven't really looked.

Tag Motorsports in the US do standard badges in black etc. Check out the RS6 C7 forum on Audizine.

Al

ERS35 wrote:There you go mate

http://www.raywelldesign.com/

I just got the Black RS6 badge for the boot from them and it looks good.
http://www.raywelldesign.com/shop/rs6-black-badge/