Short plate

[skirs6]

How much fella?

SOLD to you sir

[RS6chris!]

Cheers pal

You got PM

[prestigewheelcentre]

Does anyone know the part number for this? Not sure if this questions has come up before?

[Anth]

Does anyone know the part number for this? Not sure if this questions has come up before?

Been on here a few times, part number ; 4G0 807 285 S

[rtd]

Does anyone know where they can make a plate up to fit that holder?


Sent from my iPhone using Tapatalk

[Iain]

I use these guys for my short plate - next day delivery
https://www.myshowplates.com/number-plate-designer.asp

13"x4.5"

[Mr Footlong]

I don’t understand why that small plate holder is not available. It’s an official Audi part. That must have been my best purchase thanks to Bem. Just the cost of postage. Top man

How much fella?

PM me with an offer mate

Nice to see you "paying it forward" for a fellow forum member then.

[MikeFish]

Haha good memory footers.

[skirs6]

I don’t understand why that small plate holder is not available. It’s an official Audi part. That must have been my best purchase thanks to Bem. Just the cost of postage. Top man

How much fella?

PM me with an offer mate

Nice to see you "paying it forward" for a fellow forum member then.

. You need to get out more

[zappy-chops]

Hi folks, I am looking to put a private plate with either 4 or 6 digits on the RS6 and found this thread. I cannot find anyone selling the short plate holder mentioned in this thread (part # 4G0807285S) but from other comments it seems Audi can get it for you. Does anyone have the dimensions of it? The plates I am getting made up are sized as follows:

4 digit - 330mm x 111mm
6 digit - 406mm x 111mm

Don't know if either is a match for this short plate holder.

[Scotty C]

Hi folks, I am looking to put a private plate with either 4 or 6 digits on the RS6 and found this thread. I cannot find anyone selling the short plate holder mentioned in this thread (part # 4G0807285S) but from other comments it seems Audi can get it for you. Does anyone have the dimensions of it? The plates I am getting made up are sized as follows:

4 digit - 330mm x 111mm
6 digit - 406mm x 111mm

Don't know if either is a match for this short plate holder.

I don't think the above short plate holder will fit the FL version as there is a slight variation in width of the screw holes...

[zappy-chops]

I don't think the above short plate holder will fit the FL version as there is a slight variation in width of the screw holes...

Ah - there goes that plan then. Unless I can just modify the plate holder with new screw holes?! I am finding it impossible to source short plate holders the size I need. Plenty on ebay at 460mm but too big for what I am looking for. I could just stick the plate to the grill, but I think it looks much better in a holder. I could try to modify a normal plate holder to the size I need but I suck at DIY and will surely make a pig's ear of it.

[MikeFish]

Modifying the plate holder with new screw holes won't be easy as the holder has recessed channels that the screws sit in.

[zappy-chops]

Modifying the plate holder with new screw holes won't be easy as the holder has recessed channels that the screws sit in.

Dremel?

[MikeFish]

Modifying the plate holder with new screw holes won't be easy as the holder has recessed channels that the screws sit in.

Dremel?

In my opinion it would be easier to modify a long facelift holder than try to make a short pre facelift one fit.