Page 1 of 1
guaging interest MTM cast 2.7t manifolds
Posted: Tue Apr 22, 2008 9:54 am
by dummi
I am likely going to work on a pair of XS power mani's with my fingers crossed, so want to know what interest for these is like, they are MTM larger porter than OEM and ceramic coated cast iron. pm me
RE: guaging interest MTM cast 2.7t manifolds
Posted: Wed Apr 23, 2008 6:05 am
by ZKNY
dont mess w XS. it is made in china garbage. dont waste your time and $. trust me. MTM is overpriced and similar to oem log style manifold- no advantage. get genjdm or mrc.
RE: guaging interest MTM cast 2.7t manifolds
Posted: Wed Apr 23, 2008 6:27 pm
by dummi
hmmm, thanks?
I have a set of MTM ceramic coated in two minds whether to sell them so I can get some cams, they are cast iron can be ported further (already have large ports) and are very difficult to crack, which is not as much of a priority to me as it was before since I have a reliable 2nd car I am keeping around now in case of iminent engine pulls

RE: guaging interest MTM cast 2.7t manifolds
Posted: Wed Apr 23, 2008 6:32 pm
by grizz
FLASHYG Has them and is running over 600bhp on them.. they cant be that bad...
RE: guaging interest MTM cast 2.7t manifolds
Posted: Wed Apr 23, 2008 6:44 pm
by quattronutter
im going to use some reinforced ones too..
RE: guaging interest MTM cast 2.7t manifolds
Posted: Thu Apr 24, 2008 11:17 pm
by flashyg
Nothing but cast iron.
too many problems with the others.
No thanks.
O yea and running peak egts of 870 with 518.4 whp and low boost 28peak 24redline.
What u on about, this car flows!!
G
Re: RE: guaging interest MTM cast 2.7t manifolds
Posted: Sun Apr 27, 2008 11:40 am
by dummi
flashyg wrote:Nothing but cast iron.
too many problems with the others.
No thanks.
O yea and running peak egts of 870 with 518.4 whp and low boost 28peak 24redline.
What u on about, this car flows!!
G
can't think of a better info of what these manifolds can do! thanks flashyg and grizz