RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

For sale is my used Milltek cat back resonated and valved system with chrome tips.

This will fit the B7 RS4 Saloon, Avant and Cab

I purchased the main system in 2010 at MRC and the resonated pipes this year (2012) also from MRC. Mileage is around 18-20kmiles

Im selling due to me going back to my OEM system and Milltek cats.

This is a fantastic upgrade to any RS4, the sound of these are just awesome. Some of you may know that the non-res system can be boomy between 1800-2200rpm, the resonator pipes takes the edge of this. Bare in mind that this system has been bedded in so wont be as boomy.

Pick up only from Bromley, Kent (near SE London) 10 min from M25 jnc 4 or 5

£900

The system is wrapped ready for pick up.

bargain for someone..

your getting old fella... cant believe your going back to oem... as glenn says bargain for someone

Ivesting in the track car
Makes sense matey

sonny wrote: Bare in mind that this system .........

Bear in mind....?



Bargain IMHO

GLWS

An epic sounding system.

You have PM! I

Anything I'd need to know or do before fitting and how easy to fit?

Anything I'd he'd to bear in mind?

F@tBoyF@t wrote:

sonny wrote: Bare in mind that this system .........

Bear in mind....?



Bargain IMHO

GLWS

Oh dear, I am defiantly losing it

D_K wrote:Ivesting in the track car
Makes sense matey

Indeed mate, need roll cage funds

scaghead wrote:your getting old fella... cant believe your going back to oem... as glenn says bargain for someone

HAHA I know mate, long time coming.

EddyPee wrote:You have PM! I

Anything I'd need to know or do before fitting and how easy to fit?

Anything I'd he'd to bear in mind?

Direct plug and play, Iv never fitted one. Just make sure that they are aligned correctly and that the vacuum tubes are connected.

I hope that was on porpoise

With regards it fitting its pretty simple. It can be fiddly to align properly and in certain areas around the back box it runs close to the underside of the car so just give it a wobble to make sure it doesn't hit anywhere. Apart from that just the usual exhaust fitting tips, get some assembly paste and some WD40 to help remove/fit the rubber hangers.

The only problem you MAY have is being a 2nd hand system the pipes that connect to the Cat pipe could be slightly deformed due to prior fitting. So just have a look to ensure they're pretty much round, if not a vice/hammer would help

All the connection seem pretty good. It was mated to Milltek cats so they just connected together.

Would you be interested in shipping across the pond? If so shoot me a PM, in regards to pricing and shipping to Vancouver, Canada.

Cheers!

Sorry UK sales only

is the milltek still for sale?getting my rs on the 18th and do fancy 1 of these on it

Best mod by far, send Sonny a pm as i think its still for sale.