C7 exhaust front and centre straight through "SOLD"

[skirs6]

This is a standard C7 exhaust with the front and centre boxes removed. Works with OEM valve controls. If you want a few more pops and bangs this is it for a fraction of the cost of Milltek and other well known systems.
The work was all done by Demand engineering. Will bolt straight on the car all clips included.
At the moment it's at QST who will fit if required for a fee.
It's in three sections so easy to collect and fit yourself if you wish.
£350 collection only

[RS6chris!]

Best sounding zorst for a C7

I've got same

99.9% same noise as a milly for a few hundred quid

[skirs6]

Best sounding zorst for a C7

I've got same

99.9% same noise as a milly for a few hundred quid

Yup I got the idea from Mike

[RS6chris!]

Same here!!

[skirs6]

No takers ??? Would it make it more appealing if I offered a full refund if you have it fitted and don't like it. All you would pay for is the fitting costs. I know what it's like trying to find the right exhaust trust me. I changed my exhaust 6 times on my C6.

[gsc]

I may be interested in the rear section only but as I'm opposite end of the country would need the silencers couriering. Feasible?


Sent from my iPad using Tapatalk

[skirs6]

Everything is feasible but not sure why you would want just the rear section ?? I assume you mean rear and middle not the front pipes which normally have small silencers on

[gsc]

I have already removed the centre muffler and resonators but would like a little more sound so looking at a donor set of silencers to potentially partially / fully gut and perhaps reinsert the resonators depending on the results. Hence the enquiry.


Sent from my iPad using Tapatalk

[skirs6]

Ah ok I'm with you now. The only problem with postage is the size of the rear section as there is a small joining bar which keeps the two rear boxes at the correct distance apart. It would be much cheaper if this bar was removed and then reinstated as Paisley freight have shipped several exhausts for me in the past but all have been single exit systems which fall within their size rules.

[skirs6]

Very bad arrow but that's the bar

[carmad]

Have you still got the front pipes if you have please PM me

[skirs6]

Now on EBay at £250 plus £30 postage

[skirs6]

A couple of pics to show the bracket which I have cut to allow for postage/courier. A very simple job to re weld when ready to fit

[skirs6]

Lots of time wasters mainly EBay but also some on here I can only assume those on here that stated "I'll have it" then no reply have died??? Shame.
At the moment it's centre pipes and front all packaged ready to go £200 including postage. These will fit to your rear boxes.

[stocky68]

Pm sent