Sam came up with the answer (JHM website), to take the B7 to a 380mm disc using OEM calipers just shim/space out the caliper to allow 15mm increase in diameter and increasing the bolt length accordinglyneilparf wrote:Sorry Rich! Keppin' ya on your toes!R1RS4 wrote:"God" Neil what happened ?
Dropped off the forum yesterday lunch time and came back this morning to find this lot
What was the answer? To fit 380mm steel discs do we use the OEM caliper setup for the B7 or a custom caliper mounting plate?
cheeRS R
I had a few questions and 30 minutes later this thread is a few pages long!![]()
I'm sorry, I really don't the answer to that 380mm question. Over to anyone else?
Good luck!
Just need to find out which of the 380mm discs fit the B7 bells, QST may well know the answer to that as they are agents for movitbrakes who I have been in touch with asking the question, if not the other route would be for me to obtain a set of bells and put it together