RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

This is my second RS6. Both were purchased off forum members.
It would be nice for a fellow enthusiast to take this one too. Only ever run on VPOWER or Momentum. Never WOT until oil up to temperature

GREY Audi RS6 2010 Saloon MRC 775ps 1076nm

Registered Jan 2010
Current Mileage: 65721

Optional extras:

-Tilt and slide sunroof
-Ceramic brakes - lots of life left on all discs and pads, callipers painted in matte Red.
-Rear parking camera
-Tv tuner (Vim activated)
-Soft close doors

Modifications:
-Trups headlight bulb replacement- much brighter than factory ones. And interior LEDs
-Tracker installed - Not active currently
-Braided brake lines
-Supersprint secondary decat
-Miltek non resonated exhaust
-MRC stage 2 map and gearbox software with overrun crackles updated Feb 17 (Dyno printout included)
-YouTube link: https://youtu.be/9e7pAUvBeM8 (Now 2x Oval tips)

Oil pump seal done sept 2017 - Crawley Audi
Coolant pipes checked and no need for replacement any time soon.

Standard spec:
DAB
Bose sound system
Cruise control
Front and rear seat heating
Parking sensors Front and Rear

I have maintained this car regardless of cost during my ownership (April 2018) and the service history is as follows. I have a folder full of receipts to verify.

Recent Service history;
03/19 Unit 20- DRC hose. Fit and pressurise. £399
02/19 New battery £150
01/19 Unit 20- Full service including spark-plugs and upper arms £2194.19
10/18 GL Autos- Engine oil and Filter. Brake fluid flush and replacement. £299
04/18 Chester Transmissions- Gearbox oil replacement £285

Full Service history: (all receipts present*)
01/19- Unit 20 63k*
10/18- GL autos 60k*
09/17- Audi Crawly 54k*
09/16- Audi Crawly 49k*
12/15 Norwich Audi 41k*
09/14 Crawley Audi 32k
???????? Hull Audi 22k
11/11 Stockport Audi 11k
12/10 Preston Audi 3k

The body work is in great condition for the age, however the front does have a few stone chips and would benefit from a spray/touchup.

£24995
2 Keys 1 Valet Key
No test drives without cleared funds and comprehensive insurance please.

I was in the running a while back for this car but having the wheels nicked off my then M3 pushed my insurance quote to a figure I couldn’t live with which was (and still is) pretty depressing.
Bhav has gone way above and beyond caring for his car and this is a truly a very well cared for and sorted C6.
GLWS Bhav!


Sent from my iPhone using Tapatalk

stevo55 wrote: ↑

Fri Sep 13, 2019 11:37 am

I was in the running a while back for this car but having the wheels nicked off my then M3 pushed my insurance quote to a figure I couldn’t live with which was (and still is) pretty depressing.
Bhav has gone way above and beyond caring for his car and this is a truly a very well cared for and sorted C6.
GLWS Bhav!


Sent from my iPhone using Tapatalk

Thanks for the comments mate.

My old car and Kent Andy b4 me

great to see the old girl still being looked after. I cant buy it a 3rd time...or can i.....

Price reduced £25k ONO- No rush to sell but is this too rich?

The propshaft bearing has recently failed- I have replaced the compete item and the car is back to 100%.

Car is barely moved as I have had a replacement for sometime, and will be SORN and stored in my garage until sold.

RS6BHAV wrote: ↑

Wed Oct 30, 2019 5:37 pm

Price reduced £25k ONO- No rush to sell but is this too rich?

The propshaft bearing has recently failed- I have replaced the compete item and the car is back to 100%.

Car is barely moved as I have had a replacement for sometime, and will be SORN and stored in my garage until sold.

hi Bhav,

do you mind me asking who did p'shaft bearing for you? Assume it wasn't too costly ?

Cheers.

c3nturi0n wrote: ↑

Wed Nov 06, 2019 6:19 pm

RS6BHAV wrote: ↑

Wed Oct 30, 2019 5:37 pm

Price reduced £25k ONO- No rush to sell but is this too rich?

The propshaft bearing has recently failed- I have replaced the compete item and the car is back to 100%.

Car is barely moved as I have had a replacement for sometime, and will be SORN and stored in my garage until sold.

hi Bhav,

do you mind me asking who did p'shaft bearing for you? Assume it wasn't too costly ?

Cheers.

I brought a refurbished one from eBay.de. After phoning around a lot of places trying to get my original one fixed, was easier replacing the whole thing.

Here’s the one I got:

http://vi.raptor.ebaydesc.com/ws/eBayIS ... spheader=1

Roughly £700 delivered
Plus £60 as I wasn’t sending mine as a donor
Plus £70 for new bolts and gaskets from Audi

Labour was £150 from local specialist

Audi wanted £1500 just for parts.

The refurbished item came well packaged and has been perfect up to now. Eliminating all shakes.

NOW LIVE ON AUTOTRADER

https://www.autotrader.co.uk/classified ... on=at_cars