Four things of note.
1. Car has serious stance. Hard to show in photos but I like.
2. I went for 10mm all round. Wondering if it's a fraction too wide and 8mm would have been better.
3. Hub has a little lip on it (from the factory). I've never noticed this before despite having the wheels off a few times to clean them. This meant issue 4 was amplified.
4. Had a HUGE problem getting one of the wheels off. Due to corrosion (alloy spigot / steel hub - genius) the wheels were all very tight to get off. One of the rears took me almost 5 minutes of beating on the whole wheel with a rubber mallet. Ballache! Photo shows corrosion.
Ps - no one please comment on how dirty the car is. It's only had a simple blast off with a jetwash (not even snowfoamed!) since coming back from Germany. :p


Standard:


With spacers:


Spacers:


