Off to MRC in 10 days

[Kiteral]

Just booked the car in for a stage 1 map at MRC.

Can't wait a nice early Xmas pressie

Will give a full review when done.

[Noyjatat]

Sweet!

[xxx_mojo_xxx]

How much bhp and torque do you expect to gain? Also, how much will it cost?

[Kiteral]

Prices are on Mrc's website, as far as bhp and torque around a 20% increase, I guess !?

Mines a manual and a launch spec model (reg april '09) so will be interesting to see the results.

[chunky79]

Should be bloody quick.

[Noyjatat]

Edited due to me being a mong. Chunky has set me straight!

[chunky79]

Must be doing more than just a map then to get that sort of horsepower increase. 80 hp normally requires your car to be under performing considerably and a carbon clean in addition to exhaust, filter, remap stage 2, cold feed etc..... Around 470 hp is the highest not SC dyno I have seen on here but I could be wrong.

This is the B8 forum mate

[Noyjatat]

Cheers Chunky!

[Kiteral]

Hahohe hahahaha lovely

[Ian_C]

These are proper quick with a pulley and map, nice sounding too with the centre box removed....

[MikeFish]

They'll leave the new RS4 for dead! MRCs S4 does the 0 to 60 sprint it the low 3 seconds IIRC.

[xxx_mojo_xxx]

Is there not a downpipe upgrade available?

These are proper quick with a pulley and map, nice sounding too with the centre box removed....

[Ian_C]

Probably but gains are minimal compared to the massive gains from mapping! I'd just want a big more noise if I moved to a B8 from my non-res Milltek V8....

[evojkp]

Look forward to hearing your thoughts once you've got it done. I'm a new S4 owner and lurked for a while before getting the right one for me, with a stg 2 and pulley on my list to do early next year.

[Kiteral]

Was going to go stage 2 But want to save some pennies for when milltek release their valvesonic exhaust next year.