RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Finally got around to fitting the front splitter i bought from eBay.de, looks so much better than oem, and only twenty minutes or so to fit

Looks really good!

Do you have a link to ad you picked it up from?

http://www.ebay.de/itm/Audi-RS6-4F-C6-F ... Sw8-tWWdOI

it was on ebay UK at some point but can't find it now....

I have one of these brand new in the UK if anyone is interested in getting one.

Looks great Pete

Pete, noticed you haven't got your plates on, do you get the coppers bothering with this?

P.S Had mine in pearl white (wrapped) but took it off recently

not as yet but don't really use it that much its my weekend car, its Suzuka Grey looks white most of the time though....

Is that Grizz's old motor?

Yes mate

Ooooo nice!!! Love that car, congrats.

Golfather wrote:I have one of these brand new in the UK if anyone is interested in getting one.

Mate I've pm'd you.

I am interested in this front splitter.

May I ask how you go about replacing the oem front splitter and replacing with this one? Are there nuts/bolts to be undone? How do you get to them?

Any advice appreciated.
cheers,
john

Jack the car up, undo four screws I think??? then there are maybe ten or so press fittings to pull out, then just slide the old splitter out...
Line up new Splitter then drill ten very small holes and screw into place...
Job done