RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

I've got b14s fitted, the rear is on the lowest setting but I can't decide if I should raise it a small amount so level with the front or drop the front to match.
What do you all think?

I'd say lower the front

That looks nice, I like the black wheels. Looks bad ass.. Are you running spacers? If you are I'd think you're going to get rubbing if you go lower..

I'd say lower on the front but you'll be scrapping the bottom of the car on speed humps.

And losing droveshaft gaiters. I seem to be going though a set every year.

B14 don't like going too low, they tend to creek and moan.

jonytek wrote:That looks nice, I like the black wheels. Looks bad ass.. Are you running spacers? If you are I'd think you're going to get rubbing if you go lower..

Yeah 8mm all round, doesn't rub at all

Those 20" rims ? Looks ace mate.

Yeah that are the s5 20s, thanks mate

MikeFish wrote:And losing droveshaft gaiters. I seem to be going though a set every year.

Mike do you run any spacers up front?

No spacers at all. The RS5 wheels have ET26 so effectively spaced out 3mm compared to OEM wheels.

Ah I see, thanks

No room for spacers, especially in the rear:

Leave it, looks fine as it is

personally i would raise the rear to match the front as too low is not a good look, front is about perfect for looks and practicality.