water temp sensor location?
water temp sensor location?
Just thought id rule out the simple cheap options as to why my car is having cold idle issues. Starting with the temp sensor, anyone know the location of it? I've not looked yet so it may be obvious but thought id ask ready for tomorrow. Hopefully I've not got to remove a million things 1st...
-
- 3rd Gear
- Posts: 300
- Joined: Sun Feb 16, 2014 10:10 pm
- Location: West Yorkshire
Re: water temp sensor location?
I would start with cleaning your throttle body, then recalibrate it. If problem persists, check you antifreeze mixture.
Daytona Grey, Bilstein Coilovers, Pre-cat delete, Centre resonator delete, IM flaps/vains delete, Interior/Exterior LED kit, CAI, Black Optics.
Other car: Bread Van
Other car: Bread Van
Re: water temp sensor location?
What bearing would the antifreeze mix have? It should be ok as it had a full carbon clean a few months ago so would of been replaced then I'd assume. TB clean you say. You mean with a squirt of cleaner? Who do you re calibrate them?
Thanks....
Thanks....
-
- 3rd Gear
- Posts: 300
- Joined: Sun Feb 16, 2014 10:10 pm
- Location: West Yorkshire
Re: water temp sensor location?
I had a starting issue when cold in my old merc and it turned out to be a weak mixture. Had issues in colder weather.
You could clean the TB with a rag and a bit of carbon cleaner. Resetting is simple.
1. Turn ignition to on, but don't start the car, and press the accelerator fully down for 3 seconds.(you will hear a whirling sound)
2. Then turn the key to the off position. Let go of the accelerator. Wait now for two minutes and then remove the key.
This should reset the TB. You should get a better idle now.
You could clean the TB with a rag and a bit of carbon cleaner. Resetting is simple.
1. Turn ignition to on, but don't start the car, and press the accelerator fully down for 3 seconds.(you will hear a whirling sound)
2. Then turn the key to the off position. Let go of the accelerator. Wait now for two minutes and then remove the key.
This should reset the TB. You should get a better idle now.
Daytona Grey, Bilstein Coilovers, Pre-cat delete, Centre resonator delete, IM flaps/vains delete, Interior/Exterior LED kit, CAI, Black Optics.
Other car: Bread Van
Other car: Bread Van
Re: water temp sensor location?
All seems simple, got to be worth a go. Ill have a go this weekend. thanks...
Who is online
Users browsing this forum: No registered users and 243 guests