Exhaust

[Badman]

looks like the ECS tuning H pipe is a bust. Just called up Awsome GTI they arnt coming back in till April 2017 looks like ill just fit it to the standard exhaust set up. If I need an OEM exhaust theres loads on ebay for 100 quid

[dazzbilan]

I had a B7 RS4 which I have now sold for a C6 RS6.

On my vehicle, I had gutted the rear silencers was lead to a much better sound than stock. Full throttle accelerations sounded great along with idle revving which had a delightful roar with crackles as the revs dropped. The beauty of this process was, I managed to keep the original stock tips and valves. Was very impressed with this inexpensive mod (at just £80) and personally, I think it sounds better than offerings from a number of leading exhaust manufacturers.

Dazz

[Nickygrs4]

Dazz,
Did this make the car stupid loud or was it just nice?? Any droning inside the car?

[Deano_123]

looks like the ECS tuning H pipe is a bust. Just called up Awsome GTI they arnt coming back in till April 2017 looks like ill just fit it to the standard exhaust set up. If I need an OEM exhaust theres loads on ebay for 100 quid

You can use the Milltek non-res pipes and have them match up to the Tubi. As has been said before, its very loud

[MikeFish]

looks like the ECS tuning H pipe is a bust. Just called up Awsome GTI they arnt coming back in till April 2017 looks like ill just fit it to the standard exhaust set up. If I need an OEM exhaust theres loads on ebay for 100 quid

You can use the Milltek non-res pipes and have them match up to the Tubi. As has been said before, its very loud

Yes but the Tubi has to be cut to mate up with the Milltek.

[dazzbilan]

Dazz,
Did this make the car stupid loud or was it just nice?? Any droning inside the car?

Hi Nicky,

Non at all, for the £100 which it cost me. Was the best value mod I did on a vehicle.

Dazz

[Deano_123]

looks like the ECS tuning H pipe is a bust. Just called up Awsome GTI they arnt coming back in till April 2017 looks like ill just fit it to the standard exhaust set up. If I need an OEM exhaust theres loads on ebay for 100 quid

You can use the Milltek non-res pipes and have them match up to the Tubi. As has been said before, its very loud

Yes but the Tubi has to be cut to mate up with the Milltek.

Good point. Any half decent welder should be able to chop out the original resonator to give you straight pipes