So ive been offered a brand new set of 40mmH&R lowering springs for only £100.
having searched on here for how low people go and whether this will rub a lot I haven't really been able to find any decent information to help with my decision to take these or not,
is a B7 2007 saloon on standard rims with standard sized tyres, was maybe thinking of going down the 8mm front and 10mm rear spacers but wanted to ask first whether
1. would this rub without adding the spacers into the equation?
and
2. will it definitely rub with the added spacers?
I don't really take anymore than two maybe three people in the car ( 3 hardly ever)
cheers Guys
H&R lowering springs??
Re: H&R lowering springs??
1. No
2. Yes
FYI, your car will understeer even more with wider spacers at the back than the front.
2. Yes
FYI, your car will understeer even more with wider spacers at the back than the front.
RS4 B7, Mugello Blue, K&W V3 & HR ARBs, set up by Centre Gravity, Milltek Valved Non Res & cat bypass pipes, BMC air filter, braided hoses, DOT 5.1, Terraclean, MRC Full Carbon Clean, MRC remap 448PS 477NM, 20" S7 alloys with 4mm spacers & Hawke spigots 66.6 > 57.1, AP Racing front discs. Sold Sept 2019. Now rocking an F80 M3
Re: H&R lowering springs??
Cheers buddy!
would they still rub with 8mm spacers all round ?
if that's the case then might give the springs a miss and try and get a set of 25mm springs ?
would they still rub with 8mm spacers all round ?
if that's the case then might give the springs a miss and try and get a set of 25mm springs ?
Re: H&R lowering springs??
I would say yes if lowered, but I'm sure someone on here has done the same mod.
Spacers, different tyres, lowering, 20" alloys etc all give problems, but when you get your mods right it's great.
Good luck and post some photos.
Spacers, different tyres, lowering, 20" alloys etc all give problems, but when you get your mods right it's great.
Good luck and post some photos.
RS4 B7, Mugello Blue, K&W V3 & HR ARBs, set up by Centre Gravity, Milltek Valved Non Res & cat bypass pipes, BMC air filter, braided hoses, DOT 5.1, Terraclean, MRC Full Carbon Clean, MRC remap 448PS 477NM, 20" S7 alloys with 4mm spacers & Hawke spigots 66.6 > 57.1, AP Racing front discs. Sold Sept 2019. Now rocking an F80 M3
Who is online
Users browsing this forum: Bing [Bot] and 209 guests