RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Seen this and thought I would post for inspiration. Might do it myself carbon skinning it

Seen the kits my self, its a long process but the results look amazing.

Going to give this ago on my front grill and air boxes i reckon! see how i get on

I've been contemplating doing this myself- I have the benefit of having a nice small Swiss front plate that sits behind it...

I did it here -



Utter slut of a job. If you think you can do it, think again, then think about it again!!

I screwed up lots of times, lots of bits and a couple of kits - it's by far and away 10 times more difficult than fibreglassing a nightmare to lay up and even harder to get flat and all the air out the resin - such a messy job too. I swore I'd never try again! So I sent some parts away to someone else, who I kid you not, spent 40 hours doing one part for me.

https://www.youtube.com/watch?v=7N5N-AYaENI

Well, close enough! Takes just 1% of the time - and its removable!