Bulging lower door trim

4.2 V8 32v Naturally Aspirated - 414 bhp
markwm
3rd Gear
Posts: 257
Joined: Thu May 04, 2006 11:45 am

Re: Bulging lower door trim

Post by markwm » Thu Apr 16, 2015 12:59 pm

Just open the door and look at the bottom corner near the hinge end and the bottom corner at the pillar end, two visible screws.

User avatar
Ellis
2nd Gear
Posts: 219
Joined: Sun Mar 01, 2015 1:55 pm
Location: Aberdeenshire

Re: Bulging lower door trim

Post by Ellis » Thu Apr 16, 2015 1:16 pm

markwm wrote:Just open the door and look at the bottom corner near the hinge end and the bottom corner at the pillar end, two visible screws.
Ahh on the inside. I knew it was a stupid question. Many thanks.

User avatar
R1RS4
5th Gear
Posts: 1079
Joined: Wed Oct 02, 2013 10:07 pm
Location: South of England

Re: Bulging lower door trim

Post by R1RS4 » Thu Apr 16, 2015 4:44 pm

Good write up, must have a go at this mine are the same

Always good to have a go

I had a rear off side window trim that's bug me since Ive had the car,(18 months) always thought maybe the door had taken a knock and the door was misaligned, and it been in Audi about 5 times

I have tried pressing and moving the trim but no luck, so after washing the car the other day, I thought right doing that trim even if I have to take the door to pieces, went up to the trim with cloth pushed really hard and it clipped into place, nothing wrong with the door all looks good... Good job done by a <beep>!
RS4 B7 Avant,2007
Metallic black, Black optics pack, Black gloss Wheels, Milltek black tipped -valved, MRC Installed TTS Supercharger 610ps/626nm, MRC stage 3 remap, CAF, DRC/SS+ with H&R spacers, carbon race splitter, carbon trim

Deano_123
3rd Gear
Posts: 285
Joined: Fri Jun 20, 2014 2:04 pm
Location: Newcastle

Re: Bulging lower door trim

Post by Deano_123 » Fri Apr 17, 2015 5:32 am

markwm wrote:Two screws on the inside of the door at either end, then it just slides out. Really easy.
So no need to remove the door card then?
Image

GlenRS
1st Gear
Posts: 71
Joined: Sat Aug 11, 2012 8:04 am

Re: Bulging lower door trim

Post by GlenRS » Fri Apr 17, 2015 9:13 am

Deano_123 wrote:
markwm wrote:Two screws on the inside of the door at either end, then it just slides out. Really easy.
So no need to remove the door card then?
No, they are below the door card. Two little black screws right at the bottom of the door at either end. You cant miss them with the door open

Post Reply

Return to “RS4 (B7 Typ 8E) 2006–2008”

Who is online

Users browsing this forum: No registered users and 243 guests