here is a pic of the c
Is breaking the silver hose clip off an answer as they are cheap but you really need some hose pliers to attach a new one.
Carbon clean with DIY walnut shell blaster
Re: Carbon clean with DIY walnut shell blaster
[quote="voidopolis"]
here is a pic of the c
Is breaking the silver hose clip off an answer as they are cheap but you really need some hose pliers to attach a new one.
here is a pic of the c
Is breaking the silver hose clip off an answer as they are cheap but you really need some hose pliers to attach a new one.
RS4 B7, Mugello Blue, K&W V3 & HR ARBs, set up by Centre Gravity, Milltek Valved Non Res & cat bypass pipes, BMC air filter, braided hoses, DOT 5.1, Terraclean, MRC Full Carbon Clean, MRC remap 448PS 477NM, 20" S7 alloys with 4mm spacers & Hawke spigots 66.6 > 57.1, AP Racing front discs. Sold Sept 2019. Now rocking an F80 M3
-
voidopolis
- Neutral
- Posts: 21
- Joined: Fri Jul 04, 2014 3:41 am
Re: Carbon clean with DIY walnut shell blaster
hmm. I should have considered that... FYI: those little silver clamps are made of tough metal... I was surprised how difficult they were to cut. I had to remove two others when getting different hoses off.Covkiller wrote:Is breaking the silver hose clip off an answer as they are cheap but you really need some hose pliers to attach a new one.
Someone that has done this removal before - how did you squeeze that connector to get it off? diagonally or both sides at the same time? I just can't figure it out. maybe folks are just cutting off the metal band...
Who is online
Users browsing this forum: No registered users and 94 guests