B7 RS4 O2 sensor

4.2 V8 32v Naturally Aspirated - 414 bhp
Post Reply
Cupraderv
1st Gear
Posts: 61
Joined: Mon Dec 04, 2017 4:02 pm

B7 RS4 O2 sensor

Post by Cupraderv » Mon Apr 20, 2020 6:57 pm

Got a wee misfire when cold and got fault code P2234 O2 sensor signal circuit shortened to heater circuit bank 2 sensor 1
Got told I need part no 1K0 998 262 AA. Anyone know best place to purchase this without going to main dealer

mikep99
4th Gear
Posts: 725
Joined: Fri Jul 17, 2015 9:03 am

Re: B7 RS4 O2 sensor

Post by mikep99 » Mon Apr 20, 2020 7:11 pm

Looks like that part number equates to Bosch no. 0258007363.
There's quite a few listed on ebay, eg. https://www.ebay.co.uk/itm/Bosch-Lambda ... Sww~xZ2ShK

HTH
Mike

Cupraderv
1st Gear
Posts: 61
Joined: Mon Dec 04, 2017 4:02 pm

Re: B7 RS4 O2 sensor

Post by Cupraderv » Mon Apr 20, 2020 7:23 pm

Thanks for quick reply mate

Quango86
2nd Gear
Posts: 151
Joined: Thu Jan 31, 2019 2:08 pm

Re: B7 RS4 O2 sensor

Post by Quango86 » Mon Apr 20, 2020 9:07 pm

I just replaced the same sensor last week. Got it from dingbro comes with a long cable but was 120 quid
B7 saloon, koni Shocks and h and r springs, h and r spacers 8mm f+r, milltek non res with valves, milltek d/ps, k and n filter, full mrc carbon clean, mrc stage 2 with l/c and f/s 456bhp 522nm.

Cupraderv
1st Gear
Posts: 61
Joined: Mon Dec 04, 2017 4:02 pm

Re: B7 RS4 O2 sensor

Post by Cupraderv » Tue Apr 21, 2020 7:27 am

Hi was that a genuine one mate, is it a nightmare to fit

Quango86
2nd Gear
Posts: 151
Joined: Thu Jan 31, 2019 2:08 pm

Re: B7 RS4 O2 sensor

Post by Quango86 » Tue Apr 21, 2020 8:17 am

No it's easy enough drop the rear gear box mount to give you more room to get the plugs out. It was a bosch 1 same part numbers
B7 saloon, koni Shocks and h and r springs, h and r spacers 8mm f+r, milltek non res with valves, milltek d/ps, k and n filter, full mrc carbon clean, mrc stage 2 with l/c and f/s 456bhp 522nm.

Cupraderv
1st Gear
Posts: 61
Joined: Mon Dec 04, 2017 4:02 pm

Re: B7 RS4 O2 sensor

Post by Cupraderv » Tue Apr 21, 2020 10:58 am

No worries mate will message Dingbro
Cheers

Post Reply

Return to “RS4 (B7 Typ 8E) 2006–2008”

Who is online

Users browsing this forum: Zyox and 103 guests