just wondering if anyone can post up their results....
Age of car, type and mods
Type of dyno
Flywheel horsepower or wheel horsepower figures
Torque figures
Gear it was run in
ESP / traction settings?
I'll start it off
-------------------------
2007 saloon. no mods
Dyno Dynamics
366 f/hp
just over 300 lb/ft torque.
4th gear
Only switched the 1st stage of ESP off (so flashing on dashboard) hadnt realised I needed to hold the switch down for 3 seconds to totally deactivate it - cause of low result??
--------------------------
dynos- whos had theirs on and what were the results?
-
- 1st Gear
- Posts: 66
- Joined: Thu Sep 10, 2009 4:36 pm
2006 Avant, no mods at time
2007: 19000 miles
Dyno Dynamics (WRC Technologies)
385 bhp 4th Gear Shoot_44
ESP Fully off
2009: 46000 miles
Dyno Dynamics (Paramount)
359 bhp 4th gear Shoot_44
ESP Fully off
2009: 50000 miles
Dastek (Motoscope)
396 bhp 4th Gear
ESP Fully off (no effect sport mode on/off)
2007: 19000 miles
Dyno Dynamics (WRC Technologies)
385 bhp 4th Gear Shoot_44
ESP Fully off
2009: 46000 miles
Dyno Dynamics (Paramount)
359 bhp 4th gear Shoot_44
ESP Fully off
2009: 50000 miles
Dastek (Motoscope)
396 bhp 4th Gear
ESP Fully off (no effect sport mode on/off)
Dyno Result
2006: 30000 miles
Dastek (Motoscope)
356 bhp @ 7687rpm (4th Gear)
300lbf @ 3468rpm
ESP Fully off
I subsequently found out that I had a vacuum leak from a hose connected to the exhaust which resulted in power loss.
http://s889.photobucket.com/albums/ac10 ... t=Hose.jpg
Dastek (Motoscope)
356 bhp @ 7687rpm (4th Gear)
300lbf @ 3468rpm
ESP Fully off
I subsequently found out that I had a vacuum leak from a hose connected to the exhaust which resulted in power loss.
http://s889.photobucket.com/albums/ac10 ... t=Hose.jpg
06 Black RS4 Saloon
-
- 1st Gear
- Posts: 66
- Joined: Thu Sep 10, 2009 4:36 pm
Re: Dyno Result
any more pics of where this hose is or are we talking about the valve on the rear tailpipe? Difficult to tell for sure from the pics Wouldnt mind checking this out alsogogsyp wrote:
I subsequently found out that I had a vacuum leak from a hose connected to the exhaust which resulted in power loss.
http://s889.photobucket.com/albums/ac10 ... t=Hose.jpg
Re: Dyno Result
Yeah, it was the hose connected to the tailpipe. It was easily fixed by plugging the hose with a grub screw; I also did the other one; now the car is on loud mode all the time.Grazer_skredge wrote:gogsyp wrote:
any more pics of where this hose is or are we talking about the valve on the rear tailpipe? Difficult to tell for sure from the pics Wouldnt mind checking this out also

If you are suffering from vacuum loss the EPC light should of come on because the tumble flaps in the inlet manifold are also operated using the vacuum system & if they aren't opening properly it should log a fault.
06 Black RS4 Saloon
Who is online
Users browsing this forum: Google [Bot], Google Adsense [Bot] and 79 guests