RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Hi Everyone,
Ive been looking at exhaust options but will probably go with a local company. However this just popped up, will it be as bad as welding some tin cans on? Has anybody ever heard of them?

https://www.ebay.co.uk/itm/Exhaust-Cent ... 635-2958-0

I think that will drone like hell personally.

For that money I wouldn't expect anything good.

Are these Milltek ones no longer available? https://milltekshop.com/cat-back-resona ... -ssxau354/

srichards wrote: ↑

Thu Apr 21, 2022 2:40 pm

For that money I wouldn't expect anything good.

Are these Milltek ones no longer available? https://milltekshop.com/cat-back-resona ... -ssxau354/

1k Vs less than 200 quid I think was the reason for looking at the other one.

I think the above one is highly likely to be awful and need replacing again so it's a waste of money. With a silencer delete if it's too noisy it will attract attention you don't want as well.

I've had exhausts welded up before. That's often better than putting on a cheap one if the one on it is actually a good one and just needs a bit of repair.

There's also Powerflow. They were a name I remember as being ok for custom exhausts.