Page 1 of 1

Rear disk minimum thickness

Posted: Sun May 08, 2016 9:45 am
by atledreier
Anyone know how much wear is allowed?

Sent fra min SM-N910F via Tapatalk

Re: Rear disk minimum thickness

Posted: Sun May 08, 2016 10:08 am
by Shoppinit
It's stamped on the disk bell. 20mm IIRC.

Re: Rear disk minimum thickness

Posted: Sun May 08, 2016 4:45 pm
by jockthedog
atledreier wrote:Anyone know how much wear is allowed?

Sent fra min SM-N910F via Tapatalk
You are in serious danger of sounding like a Scot! Or perhaps even a Geordie! Good work.
Too much wear is not allowed. Otherwise, Feck it.

Re: Rear disk minimum thickness

Posted: Sun May 08, 2016 5:53 pm
by atledreier
Nice, that means I've got plenty life left in them. Going to have them on a lathe since they are a bit rusted on the edge.

Sent fra min SM-N910F via Tapatalk

Re: Rear disk minimum thickness

Posted: Sun May 08, 2016 6:07 pm
by ahoooga
atledreier wrote:Nice, that means I've got plenty life left in them. Going to have them on a lathe since they are a bit rusted on the edge.

Sent fra min SM-N910F via Tapatalk
probably last you another 5 years. They don't really do much tbh