2003 RS6 Tool what's missing?
2003 RS6 Tool what's missing?
hello,
Just got the wheels back from a refurb and noticed the tool for removing the plastic wheel nut covers is missing. What else is missing
attached a picture of the tool kit and car, not cleaned properly but going well.
lapman
Just got the wheels back from a refurb and noticed the tool for removing the plastic wheel nut covers is missing. What else is missing
attached a picture of the tool kit and car, not cleaned properly but going well.
lapman
Re: 2003 RS6 Tool what's missing?
Your missing the electric air pump and screw driver by the looks of it.
R18 GTX Estate > Saphire 2.0i Ghia > R19 16v > Vectra V6 SRi > M3 > RS6 Avant
Re: 2003 RS6 Tool what's missing?
That's a start then,
Thanks
lapman
Thanks
lapman
Re: 2003 RS6 Tool what's missing?
If you're going to be picky, you best check the date on your tyre goo. It'll most likely be out-dated.
No matter where you go, there you are.
Re: 2003 RS6 Tool what's missing?
Then throw it away and replace with a chocolate teapot, it'll be about as much use.bam_bam wrote:If you're going to be picky, you best check the date on your tyre goo. It'll most likely be out-dated.
Re: 2003 RS6 Tool what's missing?
If the tyre goo is a load of poo, what do people recommend using? I shall be heading down to the Alps in a few weeks so want to be prepared in case I get a puncture.
RS6 C5, MTM
Re: 2003 RS6 Tool what's missing?
A spare tyre on a rim if you can get one in! I gad a puncture in my C6 in the middle of France on a Friday afternoon. Ball ache.
Re: 2003 RS6 Tool what's missing?
I think there's supposed to be a little spanner in there too. I'll check mine later.
You got your locking wheel nut key?
You got your locking wheel nut key?
Daytona RS6 Avant
Rule #36 - At least one gear shall be dropped for every tunnel travelled
** NOW AVAILABLE ** C5 RS6 Cambelt Tool kit rental (also fits other models 3.7/4.2 V8 engines)
Rule #36 - At least one gear shall be dropped for every tunnel travelled
** NOW AVAILABLE ** C5 RS6 Cambelt Tool kit rental (also fits other models 3.7/4.2 V8 engines)
Re: 2003 RS6 Tool what's missing?
Spanner is a 10/13mm one. God knows what you need it for though.
Last edited by Nobby on Fri Jul 04, 2014 12:42 pm, edited 2 times in total.
Daytona RS6 Avant
Rule #36 - At least one gear shall be dropped for every tunnel travelled
** NOW AVAILABLE ** C5 RS6 Cambelt Tool kit rental (also fits other models 3.7/4.2 V8 engines)
Rule #36 - At least one gear shall be dropped for every tunnel travelled
** NOW AVAILABLE ** C5 RS6 Cambelt Tool kit rental (also fits other models 3.7/4.2 V8 engines)
Re: 2003 RS6 Tool what's missing?
Yeah, you're right, I think there was a little spanner. His locking key is present though.
I haven't seen one of these for a while, I've not lifted the boot cover in the 'loon for a very long time. The avant just has a dirty big 7.5L meth tank where the tool set used to be.
I haven't seen one of these for a while, I've not lifted the boot cover in the 'loon for a very long time. The avant just has a dirty big 7.5L meth tank where the tool set used to be.
No matter where you go, there you are.
Re: 2003 RS6 Tool what's missing?
950 nm torque!
Ohh running bridgestones because they are the best
Ohh running bridgestones because they are the best

Re: 2003 RS6 Tool what's missing?
yep 03/2007 well past it's best....bam_bam wrote:If you're going to be picky, you best check the date on your tyre goo. It'll most likely be out-dated.
I had a look for a chocolate teapot as well, going to Halfords to pick one up.
There is also a back plastic thing with a thread at one end and a small at the other. Any idea what that is for?
lapman
Re: 2003 RS6 Tool what's missing?
Halfrauds has gots loads of things just as useless as chocolate teapots. Glass drum kits on special offer, too.
Daytona RS6 C5 Avant. Viper'd, Billies, Waggers, MTM box brain, C6 stoppers, xcarlink, R8 coolant cap (woohoo)
///M3 E46 | XC90 (V8, natch) | Passat GTE | RR Classic V8 flapper
"The major difference between a thing that might go wrong and a thing that cannot possibly go wrong is that when a thing that cannot possibly go wrong goes wrong it usually turns out to be impossible to get at and repair."
///M3 E46 | XC90 (V8, natch) | Passat GTE | RR Classic V8 flapper
"The major difference between a thing that might go wrong and a thing that cannot possibly go wrong is that when a thing that cannot possibly go wrong goes wrong it usually turns out to be impossible to get at and repair."
Re: 2003 RS6 Tool what's missing?
That is for positioning your nuts into the alloys!lapman wrote:
There is also a back plastic thing with a thread at one end and a small at the other. Any idea what that is for?
lapman
950 nm torque!
Ohh running bridgestones because they are the best
Ohh running bridgestones because they are the best

Who is online
Users browsing this forum: rs4wagon and 63 guests